
SYNCHRONIZATION FUNCTION FRISBEE SENDING
Press the button to control both of its feet
slide forwards synchronously.
Press the button to control both of its feet
slide backwards synchronously.
It includes two steps in the function: Press the
button and after its sound suggestion, press
the button to send the frisbees. You can
operate it many times in a certain time.
(If the operating order is reverse, you can't
send frisbees. Put the frisbees into the round
canister on its head before operating.)
11
12
HEAD FUNCTION TURNING FUNCTION
Start button
Press the button to control its head turn to
left and sound out.
Press the button to control its head turn to
right and sound out.
Press the button to control it turn to left.
Press the button to control it turn to right.
5
5
6
6
7
7
8
8
9
10
Battery Installation
1.The robot takes four AA 1.5V batteries.
(not included)
Robot battery installation:
a.Using a screwdriver loosen the screw on the
battery compartment.
b.Insert four AA 1.5V batteries making sure you
follow the designated “+”,“- ” signs.
c.Close the battery compartment.
Warning
1.Please do not try and recharge batteries, always
replace them.
2.Incorrect use of batteries may cause damage, so
please pay attention to the following:
(a)Do not install batteries with opposite polarity.
(b)When not in use, please switch to OFF position
and if the robot is not going to be used for a long
time, please remove batteries to avoid corrosion.
(c)Do not mix old and new batteries.
(d)Please replace exhausted batteries as soon as
possible.
(e)Keep batteries away from children.
( f)Do not place batteries near fires or expose them to
strong sunlight or damp conditions.
(g)Please dispose of batteries carefully.
3. Please don’t use it in the strong sun. Don't shoot at the
people when you send frisbees.
4. Do not eat small parts taken down.
5. Do not place it near fire, high temperature or damp
condition.
6. For not to pollute the environment, please don’t throw
package away casually.
Remote control battery installation:
a.Using a screwdriver loosen the screw on the
battery compartment.
b.Insert two AA 1.5V batteries making sure you
follow the designated “+”,“- ” signs.
c.Close the battery compartment.
2.The remote control takes two AA 1.5V
batteries. (not included)
Important:Please Do Not aim discs at persons or animals when firing.
ONOFF