Fiat 500 push car User manual

Read Operation Instructions
Carefully Before Use
Fiat 500 push car
: f
Please read the
installation instructions
carefully before
installation
Contents
I. Product Specifications and Parameters
II. Components List
Ill. Assembly Diagram
IV. Installation and replacement of steering
wheel batteries
V.
Function and Operation
VI. Simple Fault Removal Guidance
VII. Care and Maintenance
VIII. Warning
IX. Dimensions of entire car

I. Product Specifications and Parameters
1.
This product is applicable for children with 2-6 years old and must be used under supervision of the adults!
2.
Product dimensions: 86.7x54.7x92cm
3. Product maximum load weight: 23 kg
4. Product operating ambient temperature: 0-40CC
5.
Steering wheel power supply: 2x1 .5V AA battery (excluded in this product)
II. Components List
1. Car Body
6. Wheel cover
4PCS
-;t
12. Ring
4PCS
7. Seat 13. Latch spring
4PCS
2. Windshield
..- 8. Seat backrest 14. screw 4x 1 5TAB(D=7.5)
3. Steering Wheel
9. Push handle 15. Steering wheel screw
(5x33PM)
4. Rear-view mirror
2PCS
10. Rear wheel axle
---------.
-
16. Steering wheel
locknut (51MM)
5. Wheel
11. Plastic tube
4PCS
2PCS
Ill. Assembly Diagram
Installation of rear axle and wheel
o
Insert rear axle shaft (part 10) in specified position of vehicle body.
@ Install rear-wheel rubber sleeve (part 11), vehicle wheel (part 5) andiron washer (part 12) in rear axle shaft
successively, and then clamp retaining spring (part 13) in groove of the axle, finally tightly clamp wheel cover
(part 6).
O
Put the wheel (part 5) and ring (part 12) into the front axle in sequence, clamp them into the groove position
of the axle with the latch spring (part 13) and fasten the wheel cover (part 6).

2. Installation of steerinq wheel 
3. Install seat and seat backrest
15
3
16
2
(Mount the battery of the steering 
Install the seat (part 7) in the specified position of the vehicle body, tighten
wheel as per Point 4.) Install the it with screws (part 14). And then install seat backrest (part 8) in the
steering wheel (part 3) on the specified position of the vehicle body as shown in the figure, align the
J-shaped stick, and then tighten
position of each button before installation and then tighten it with screws
it with the steering wheel screw (part 14) of the seat backrest.
(part 15) and locknut (part 16).
4. Installation of windshield and rear-view mirror
Install the windshield (part 2) and rear-view mirror (part 4) at the assigned location of the car front end, find each
buckle position before installation, and then press it forcefully until each buckle position is tight.
5.
Install pull grip
Press height setting button
The installation personnel shall stand by the tail of the
baby car, find the direction of the small salient point at
the bottom of the push handle (see the figure below),
use the left hand to grip the big pipe lower end of the
push handle, and use the right hand to hold the push
handle head. OUse the thumb to press the push
handle button; (D Use the right hand to vigorously
press down the push handle;
0
Observe whether
the two small salient points at the bottom of the push
handle entirely pinch in, simultaneously insert the push
handle into the installing hole bottom of the baby car
tail, and turn the push handle to control the front-wheel
steering after hearing the "click" sound.

Press the top button of the push handle
for unlocking to shorten or lengthen the
push handle, and lock the push handle
to another height when hearing
the "click" sound.
IV.
Installation and replacement of steering wheel batteries
Battery box is at the bottom of the steering wheel. Turn over the steering wheel and open the cover of the battery
box. To replace the batteries, firstly take out old batteries, align positive and negative poles of the battery, install
two AA batteries, close the cover and tighten the screws.
V. Function and Operation
(1). How to use the handcart and sliding baby car
1.
When the foot treadle stretches out, the children's both feet shall tread on the foot treadle, and the adult can
push the baby car through the push handle and swing the push handle to realize the rotation direction of the
front-wheel.
2.
When the foot treadle shrinks to the seat bottom, the children shall stably sit on the baby car, use the both hands
to grip the steering wheel, and use the both feet to tread on the floor to slide the baby car through small steps.
3.
Stretch out and draw back the foot treadle
Push the foot treadle according to the arrow direction in Figure 0 to draw back the foot treadle to the seat bottom,
conversely, pull the foot treadle according to the arrow direction in Figures to pull out the foot treadle from the
seat bottom.
(2) Height adjustment of push handle
s height setting button
Remove the push handle,
shorten the push handle to
the the very bottom, use the
left hand to grip the big pipe
lower end of the push handle,
and use the right hand to hold
the push handle head.O
Use the thumb to press the
push handle button;
Q
Use
the right hand to vigorously
press down the push handle
(at this time, the two small
salient points at the bottom
of the push handle have
pinched in for unlocking);
0
Use the left hand to
simultaneously pull out the
push handle.

(3)
Use the push handle to control turning and open the car door
Control
turning
Open the car door
O
Press the
switch button
While pushing the baby car, swing the push handle from

Press on-off button outside the vehicle door
side to side to realize the synchronous rotation of the push

sheet, then pull the vehicle door outside and
handle and front-wheel, 
open the door.
(4)
How to use the steering wheel musical function and safety belt
0
Left music button; three sections of music, one section of music is rung when pressing the button once, these three
sections of music are circularly rung when pressing the button continuously; right music button; has the same operation
functions with the left music button, there is only difference in the circulation contents of three section of music.
0
Middle horn button at the steering wheel; one section of trumpet will be rung when pressing horn button once.
VI. Simple Fault Removal Guidance
Problems Check
Music sound is distorted
Check whether the battery power is enough, otherwise replace it.
or silent
VII. Care and Maintenance
1)
The product contains electronic components and must not be used in water or in a damp environment.
Clean it with a piece of dry cloth.
2)
The rotatable parts of baby car should be often examined to see whether foreign matters hinder the rotation
and keep a normal lubrication condition.
VIII. WARNING
1.
BATTERY WARNING
1)
This product needs to be provided with two 1 .5V AA batteries (not included in this product).
2)
Pay attention to the positive and negative poles of the battery during installation (the
reverse connection or short circuit of the positive and negative poles of the battery
is
not
allowed to occur).

3)
Rechargeable batteries charging operation can be carried out only by adults.
4)
Non-rechargeable batteries cannot be charged.
5)
The rechargeable batteries can be charged only after being taken out from the steering
wheel battery compartment.
6)
Please do not mix different types of batteries or used batteries and new batteries.
7)
If this product has not been used for a long time, the batteries shall be taken out from the
steering wheel battery compartment.
8)
Exhausted batteries are to be removed from the toy.
2. PRODUCT WARNING
1)
There may be potential sharp edges, sharp points or small parts before the assembly of this
product, and therefore this product shall be assembled by the adult.
2)
To avoid suffocation, keep the plastic bag away from children. Dispose of all bags
immediately.
3)
The children shall correctly use the car under the adult guidance and supervision,otherwise
they may make themselves or the others injured.
4)
The car is suitable for being driven on the flat ground and strictly prohibited to be driven in
such dangerous places as street, road, sleep slope and beside swimming pool,otherwise
the traffic and drowning accidents may occur.
5)
Please put on shoes and protection equipment before use, such as fastening the safety
belt and putting on the helmet, gloves, knee pads, etc.
6)
This product is only allowed to be used by a child; the maximum load is 23kg, and therefore
the overload is not allowed.
7) Keep away from fire.
8 The product instructions shall be kept as they contain important information.
3. WARNING
A! WARNING
To reduce the risk of injury, adult supervision is required.
Strictiy forbidden using on the roadways, near motor vehicles, slopes,
swimming pools and where there is water;
Please wear shoes; this toy car can only be used simultaneously by one person.
Keep away from kids before assembled by adult, as there are potentially sharp
edges, points, or small parts.
A! WARNING
Do not mix alkaline battery, standard (carbon-zinc) battery or rechargeable
(nickel-cadmium) battery.
A! WARNING
Protective equipment should be worn.Not to be used in traffic.

IX. Dimensions of entire car
.,er
M i ll
92CM
86.

54. 7CM
"Fiat" and "500" are trademarks of and licensed by the FCA Group
Companies.They are used by Dongguan Chi Lok Bo Toys Company
Limited under license.
L
K07-SMS-135002
EOO2OJ