FIBARO Smoke Sensor User manual

INSTRUCTION MANUAL
SMOKE SENSOR
FIBARO SYSTEM

Technical support
Should youneed any assistance in connecting or configuring your Home Center, please use our guides
and technical presentations which can be found on our website:
http://www.fibaro.com/en/support

Smoke sensor Temperature sensor
Signal alarm Light alarm
Functional features

Download FIBARO app for smartphone

Start the device
Twist and open the casing.
STEP 1
Take off the casing.
STEP 2

B
ee
p
!
Check if the battery
is placed correctly.
STEP 4
Remove the battery blocker
“I’m ready”.
STEP 3
Start the device
You will hear an alarm
signal while
the LED diode blinks red.

Start the device
Close the casing.
STEP 5
It’s not possible to close the
device without the battery.

Your Smoke Sensor is ready to be added
to the Home Center.
Smoke Sensormust be in range of the Home Center because it requires
a direct communication with the controller.

Start inclusion mode
Start your FIBARO application.
Go to Settings.
STEP 6

STEP 8
STEP 7
Start inclusion mode
Press “Next”.
Press “add device”.

Inclusion mode has been launched

Add your device
Quickly, triple click the button in order
to add your device to the system.
STEP 9

Processing your congurations

Wake up the device
Press the button in order
to wake up the device.
Sometimes waking up the device is not required
so it will be omitted automatically.
STEP 10

The device has been added
Name the device and
assign it to the room.
STEP 11

Network range test
You should hear a short signal while
LED diode blinks white.
STEP 12a
Hold the button
for 3 seconds.
STEP 12b
Release the button.
It is recommended to check if the device’s destination
is in range of your Home Center.

The indicator colour signalizing the quality of the network
Press the button in order
to leave testing mode.
STEP 14
Network range test
STEP 13
Press the button when
the indicator glow pink.
Direct
communication
Routed
communication
Limited
communication
No signal! The device
will not work correctly!
The quality of the network range will be
indicated by different colours of the LED diode.

Installation
1. It is recommended to install the Smoke
Sensor in all spaces that are in danger of
fire as well as the corridors between them.
3. FIBARO Smoke Sensor should be installed
in the tallest space of the room.
4. The device should not be installed in draft
places, in location with a natural smoke or
steam ( e.g. above the oven and kettle) as
well as in well lightened spaces.
2. Minimum distance:
• From walls and other objects: 40 cm,
• From lightning system: 50 cm.
• From air conditioners: 1,5 m.
During the installation it is recommended to wake up the device.

Alarm and information signal
Damage
A beep every 50 seconds
and a light alarm.
Fire
Three beeps every 1.5 seconds
and red light alarm.
Low battery level
A beep every 50 seconds
and yellow light alarm.

www.fibaro.com