fine fixtures PUB11 User manual

206 Wembly Road
New Windsor, NY 12553
Phone: [phone]
Fax: [phone]
info@finefixtures.com
www.finefixtures.com
INSTALLATION
INSTRUCTIONS
MODEL# PUB11
WITH STRAINER
BASKET
POP UP
DRAIN

INSTRUCTIONS THAT, IF IGNORED, COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR
INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
We reserves the right to change, update, modify, alter, redesign this manual/product or its policies without prior notice!
It is your responsibility to visit the website to download or contact customer service for the most updated version of the installation instructions.
We shall not be liable for any injuries or property damages in connection with this product during installation or use of this product!
• Limited warranty is void on any commercial installation.
• We are not responsible for local code compliance for this product.
• Building and plumbing codes may vary from state-to-state in accordance to your location.
• We are not responsible for providing any compliance certifications.
• We are not responsible to provide any type of certifications for this product.
• Under no circumstances we shall not be liable for any and all incidental damages sustained in connection with this product Neither
manufacture, nor distributor, nor retailer is responsible for water damage or flood caused due to use of this product.
• Under no circumstances We shall not be liable for any and all fees, cost of installation/re-installation/removal, subsequent damage or
transportation in case of the product defect.
INSTALLATION OF THIS PRODUCT BY AN
INEXPERIENCED INSTALLER MAY RESULT
IN PERSONAL INJURY OR DEATH!
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
POP UP DRAIN
2

MODEL# PUB11
DIMENSIONS/TECHNICAL DATA
3
9
ATTENTION! Dimensions may vary by up to 3/8". It is highly recommended to pull
all dimensions of actual model for installation and measuring purposes.
2 5/8”
2 1/2”
1 1/4”
4 7/8” 2 7/8”

4
• Clean the contact surface before installation.
• This item is not supposed to be twisted with
any wrench.
• Do not use polishing powder or other detergent
with powders to clean the pop-up drain.
A. Align the upper gasket onto the top flange.
B. Tape some thread seal tape onto the inter
face of the tailpiece,and connect it to the top
flange.
C. lnsert the pop-up drain body up through
the bottom of the sink.
D. Align the botton gasket as well as the lock
nut onto the tailpiece.
E. Place the drain body at the proper position,
and then tighten up the lock nut.
1
2

206 WEMBLY ROAD - NEW WINDSOR, NY 12553
P: 718.602.6060 F: 718.963.2082 - E: [e-mail]
TOLL FREE: 1.877.8FIXTURES
FINEFIXTURES.COM
FINE
FIXTURES
RETAIN THIS INSTALLATION MANUAL FOR FUTURE REFERENCE.