Fineart FINE 350 WASH User manual

--2
c
The following symbols are used to identify important safety information on the product
and in this manual:

WARNING!
Read the safety precautions in this section before installing,
powering, operating or servicing this product.
After receiving the fixture, please unpack and check if there is any damage due to
transportation. If any obvious damage or flaw is found, do not put it into use and co-
ntact the distributor or manufacturer as soon as possible.
This fixture is intended for professional use .only
When operating the fixture, attentions should be drawn to fire/electrical
shock hazards, ultraviolet radiation, lamp shattering or lethal injuries
caused by fall.
Read this User Mannual before mounting and ennergizing the fixture.
Observe the safety guideline and notice the warnings both in this User
Mannual and on the fixture.
Yet any safety concerns not covered hereby, contact the distributor or
service hot-line.
The fixture is intended for indoor application, its protection rating is IP20.
The fixture should be kept dry and avoid working in presence of moisture,
over-heat or heavy smokes.
The natural working temperature should be lower than 40 degrees. If
the ambient temperature exceeds 40 degrees, please stop operating
the unit immediately.
Protection against explosion
Shields, lenses and ultraviolet screens must be replaced if they have
become visible damaged to such an extent that their effectiveness is
impaired. Replace the lamp immediately if it becomes visually deformed,
damaged or in any way defected.
Protection against injury due to falls
Do not lift or carry the fixture alone.
To inspect that the structure and the truss hooks are in good condition
and can bear about 10 times the weight of the fixture.
Ensure the cover and all riggings are securely fastened, safety wire is
necessary to use as a secondary attachment.
Block access below the working area and work from a stable platform
while installing, servicing or moving the fixture.
Protection against ultraviolet radiation
Prolonged exposure to an unshielded discharged lamp can cause eye
and skin burns. Do not stare directly into the light output. Never look at
an exposed lamp while it is lit.
Never operate the fixture with missing or damaged lenses and/or covers.
Change the damaged head lens, shields or covers immediately.
Protection against over heat
-3-

--4
Please do not install the fixture onto combustible surface.
Do not attempt to bypass the thermostat switch or fuse.
Replace defective fuses with specified ratings only.
Keep flammable materials far away from the fixture. Minimum distance
from the flammable materials is 0.5m.
Protection against electrical shock
All electrical connections must be performed by a qualified person with
technical certificate.
Make sure that the mains power supply you use is up to local construc-
tion and electronic code regulation, the over-load protection reliable
earthing is essential.
Each fixture must be grounded correctly, and be installed according to
related regulation.
Disconnect the fixture from AC power before removing or installing any
cover or part, including the lamp and fuses, and when not in use.
Do not expose the fixture to rain or moisture.
Protection against burning or fire
The maximum working temperature of the exterior surface,under a
thermally steady state,is 84
Please don’t touch the moving head during movement.
Do not illuminate surfaces within 3.55 meters of the fixture Prohibitpro.
ecting object in short distance.
Ensure a minimun clearance of 0.1m around the cooling fans and
ventilations
Do not place any filter or other object onto the optical lens.
Allow the fixture to cool for at least minutes before transit
Do not revise the fixture or install any parts not from Guangzhou CHAI
℃.
.
15 .
YI LIGHT Co.Ltd.
3.55