Firesense Mojave Sun IR MS-1500WOIRPH User manual

Inner support
tube
Electrical junction
box points down,
tilt switch box is
on top
Mounting bracket &
curved upper arm
assembled in proper
upright position.
Inner support tube
positioned up thru
telescopic pole
Telescopic
Pole
Rivets - bottom of
inner support tube
Electrical cord
outlet opening
Lever Clamps
& Knobs
Base & Wheel
assembly with
support
collar/flange
Attach support collar/flange to base. Thread collar thru hole in baseand Hand tighten
securely. See Fig. 2A.

Electrical cord
routed thru
telescopic body
and out thru
outlet opening
near base

Creates a
generous zone
of comfort!
19 ft
10.6 ft
10 ft
98" 45degrees
Angle of
Heat spread
Grounded outlet
box cover
Grounding Pin

4.5" x 7" x 22"
Base w/Wheel Assembly - Use non-abrasive cleaners and a soft cloth. Any scratches,
chips or rust spots can be touched up using an exterior matte finish, black paint.

Clip ends must be
aligned as close to
end connectors of lamp
tube when installed. Do NOT
allow to touch tube lamp itself.
Metal friction clips
Push apart sligtly
to remove
lamp tube end
connectors
Remove & Replace ENTIRE Lamp assembly
including lamp, end connectors & wire lead
NOTE: do NOT allow any metal to contact actual lamp tubeNOTE: do NOT allow any metal to contact actual lamp tube
Connecting wire
lead

Fire Sense and Well TraveledLiving are registered trademarks of Well Traveled Imports, lnc . All assembly instruction presentations are the property of Well
Traveled Imports, lnc. and are protected by U.S.copyrights and trademarks. All rights reserved.
RR
R
R