
Page 4 Panda PMS 5000LPE_Operationinstruction.R04 - Table of contents 21.10.08
Table of contents
C.5.1 Installation of the standard exhaust system .......................................................................49
C.5.2 Exhaust / water separator ..................................................................................................50
C.5.3 Installation exhaust/water separator ..................................................................................51
C.6 Fuel System Installation .................................................................................................53
C.6.1 General References ...........................................................................................................53
C.6.2 The electrical fuel pump .....................................................................................................54
C.6.3 Connection of the fuel lines at the tank ..............................................................................54
C.6.4 Position of the pre-filter with water separator ....................................................................55
C.6.5 Bleeding air from the fuel system ......................................................................................55
C.7 Generator 12V DC System-Installation .........................................................................56
C.7.1 Connection of the 12V starter battery ................................................................................56
C.8 Generator AC System-Installation ................................................................................58
C.8.1 Installation with looped in AC-Control box .........................................................................58
C.8.2 Installation AC-Box / distribution panel separate connected .............................................59
C.8.3 AC-Control box with VCS and ASB ...................................................................................61
C.8.4 VCS-voltage controll ..........................................................................................................62
C.8.5 Jump start at hight starting current (Booster) ....................................................................63
C.9 Insulation test .................................................................................................................63
C.10 Instructions on preventation of galvanic corrosion ....................................................64
D Mode of Operation of the Generator...........................................................................65
D.1 Mode of Operation of Operating Surveillance ..............................................................65
D.1.1 Regulation of the generator voltage by the VCS ................................................................67
D.1.2 Overloading of engine during longer operation...................................................................67
D.1.3 Use the failure bypass switch for the fuel delivery..............................................................68
D.2 Operation of electric motors with high starting current ..............................................68
D.2.1 General references.............................................................................................................68
D.2.2 Compensation of 1 phases engines ...................................................................................68
D.2.3 Compensation of 3 phases engines ...................................................................................68
D.3 Operation of the generator with automatic start ..........................................................69
D.4 Operation of the generator with installation under the waterline ...............................69
D.4.1 Control of the vent valve.....................................................................................................70
D.5 Operation of the generator with installation over the waterline..................................70
E Maintenance Instructions............................................................................................73
E.1 General maintenance instructions ................................................................................73
E.1.1 Checks before starting .......................................................................................................73
E.1.2 Hose elements and rubber formed component in the sound cover ...................................73
E.1.3 Oil circuit maintenance ......................................................................................................73
E.2 Execution of an oil change ............................................................................................74
E.3 Checking the water separator in the fuel supply .........................................................76
E.3.1 De-aerating the fuel system ...............................................................................................76
E.3.2 Exchange the air filter ........................................................................................................77
E.4 De-aerating of the coolant circuit / freshwater ............................................................78
E.4.1 Exchange of the v-belt for the internal cooling water pump ...............................................79
E.5 The raw water circuit ......................................................................................................81
E.5.1 Clean raw water filter .........................................................................................................81
E.6 Causes with frequent impeller waste ............................................................................81
E.6.1 Exchange of the impeller ...................................................................................................82