Fisher & Paykel DishDrawer DS603H User manual

User guide
US CA
Dishwasher
DD603 and DS603 Series Models
All manuals and user guides at all-guides.com
all-guides.com

All manuals and user guides at all-guides.com

Installation checklist
Your installer MUST have completed and checked the following:
The DishDrawer
®is square and level.
The DishDrawer
®is fastened securely to the cabinetry.
Ensure moisture protection tape has been applied and the cabinet is sealed according to the
DishDrawer®Installation Instructions.
The DishDrawer
®opens and closes freely. The DishDrawer® must be free to close completely with
no resistance from cabinetry.
For the integrated models, check the
5/16” air gap has been achieved in the correc t place.
The power supply is connected and switched on.
The inlet water hose is connected and turned on. There should be no leaks.
The drain hose(s) are connected and there are no leaks. There must be no kinks, or obstructions
in the drain hose(s).
The spray arm is in the center and can freely rotate.
Therinseprogramhasbeenrun.
The water level will be below the stainless steel filter plate at the end of the wash program. It is
normal to find some water in the drain filter area.
Set the water softener to the correct water hardness for your area.
Important!
The installer is responsible for the DishDrawer® installation. Incorrect installation is not
covered by warranty.
All manuals and user guides at all-guides.com

Important safety information
Save these instructions
WARNING!
For your safety, follow basic precautions when using your DishDrawer®, including the
following:
Please read all instructions before operating the DishDrawer®.
The information in this manual must be followed to minimize the risk of fire or explosion or to
prevent property damage, personal injury or loss of life.
Use the DishDrawer
®only for its intended function as described in this User Guide.
Use only detergents or rinse agent recommended for use in a domestic Dishwasher and keep
them out of reach of children. Check that the detergent dispenser is empty after the completion
of each wash program.
When loading items to be washed locate sharp items so that they are not likely to damage the
lid seal and load sharp knives with the handles up to reduce the risk of cut type injuries.
Do not touch the heater plate during or immediately after use.
Do not operate your DishDrawer
®unless all the enclosure panels are properly in place.
Do not tamper with the controls.
Donotabuse,siton,standinoronthedrawerordishrackoftheDishDrawer
®.
The cup racks are designed to support cups, glasses and kitchen utensils. When the cup racks
are in the DishDrawer®do not lean on or use the cup racks to support your body weight.
Toreducetheriskofinjury,donotallowchildrentoplayinorontheDishDrawer
®.
Under certain conditions hydrogen gas may be produced in a hot water heater system that has
not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot water system has
not been used for such a period, before using the dishwasher, turn on all hot water taps and let
the water flow from each for several minutes. This will release any accumulated hydrogen gas. As
gas is flammable, do not smoke or use an open flame during this time.
Remove the door to the washing compartment when removing an old dishwasher from service
or discarding it.
Dishwasher detergents are alkaline. They can be dangerous if swallowed. Avoid contact with
skin and eyes, keep children and infirm person(s) away from the dishwasher when the drawer is
opened.
All manuals and user guides at all-guides.com

Installation
This DishDrawer
®must be installed and located in accordance with the Installation Instructions
before it is used. If you did not receive Installation Instruction sheets with your DishDrawer®, you
can order them by calling your Authorized Service Agent.
Installation and service must be performed by a qualified technician.
If the power supply cord is damaged, it must be replaced by a dealer or Authorized Service
Center or a similar qualified trades person in order to avoid a hazard.
Ensure the DishDrawer
®is secured to adjacent cabinetry using the brackets provided. Failure to
do so may result in an unstable product, which may cause damage or injury.
Do not operate this appliance if it is damaged, malfunctioning, partially disassembled or has
missing or broken parts, including a damaged power supply cord or plug.
Do not store or use petrol, or other flammable vapors and liquids in the vicinity of the
DishDrawer®.
Connect to a properly rated, protected and sized power supply circuit to avoid electrical
overload.
Makesurethatthepowersupplycordislocatedsothatitwillnotbesteppedon,trippedoveror
otherwise subject to damage or stress.
Do not install or store the DishDrawer
®where it will be exposed to temperatures below freezing
or exposed to weather.
Do not use an extension cord or a portable electrical outlet device (e.g. multi socket outlet box)
to connect the DishDrawer®to the power supply.
Maintenance
Do not repair or replace any part of the appliance or attempt any servicing unless specifically
recommended in this User Guide. We recommend that you call an Authorized Service Agent.
Keep the floor around your appliance clean and dry to reduce the possibility of slipping.
Keep the area around/underneath your appliance free from the accumulation of combustible
materials, such as lint, paper, rags and chemicals.
When cleaning the underside of the filter plate, care must be taken on the sharp outer edge to
avoid the risk of cut type injuries.
All manuals and user guides at all-guides.com

Operational
Important!
Under no circumstances should you open the drawer whilst the DishDrawer®is in operation.
Alwayspressthe button to pause and wait until you hear the three additional beeps before
opening the drawer.
The DishDrawer
®must be used with the motor assembly, filter plate, drain filter and spray arm in
place.
When disconnecting the appliance pull the plug rather than the power supply cord or junction
of cord to avoid damage.
Take care when loading the DishDrawer
®not to load dishware items so it prevents the lid from
properly sealing with the drawer. Items should be placed so they do not protrude above and/or
forced into the drawer, otherwise a service call may result.
Household appliances are not intended to be played with by children. Children or persons with a
disability which limits their ability to use the appliance, should have a responsible person instruct
them in its use. The instructor should be satisfied that they can then use the appliance without
danger to themselves or their surroundings.
Close supervision is necessary if this appliance is used by or near children. Do not allow children
to play inside, on or with this appliance or any discarded appliance.
If a Dishwasher cleaner is used, we would strongly recommend a wash program with detergent
should be run immediately afterward, to prevent any damage to the DishDrawer®.
The DishDrawer
®is designed for washing normal household utensils. Items that are contaminated
by petrol, paint, steel or iron debris, corrosive, acidic or alkaline chemicals are not to be washed
in the DishDrawer®.
If the DishDrawer
®is not being used for long periods of time, turn the electricity and water
supply to the DishDrawer®off.
Do not pour detergent or rinse agent into the salt reservoir. The detergent or rinse agent will
destroy the water softener.
Important!
This User Guide should be retained with the appliance for future reference. Should the
appliance be sold or transferred to another owner, always ensure that the User Guide is left
with the appliance in order that the new owner can become familiar with the appliance and
the relevant warnings.
All manuals and user guides at all-guides.com
all-guides.com

DishDrawer® user guide
DishDrawer®Prefinished model with LCD controls
DishDrawer®Prefinished model with no LCD controls
Contents
Installation checklist
Important safety information
Controls (Integrated badge and Prefinished
models with no LCD) 2
LCD Controls 4
Operation 6
Wash program chart 7
Caring for your dinnerware 8
Dishwasher standards test 9
Accessories 10
Loading 12
Detergent dispenser 14
Water softener 16
Rinse agent dispenser 18
Option adjustment 19
User maintenance instructions 22
Trouble shooting 25
Fault codes 28
Limited warranty 30
This User Guide explains how to operate
and maintain your new appliance
properly and safely. Please read the
whole guide carefully before starting to
use your appliance.
DishDrawer®Integrated with badge controls
All manuals and user guides at all-guides.com

2
Controls (Integrated badge and Prefinished models with no LCD)
If you have a double DishDrawer®, each drawer has
its own controls and can run independently of the
other.
Power button
The button turns the DishDrawer® on or off.
Opening the drawer will automatically turn the
DishDrawer® on for 30 seconds. To end a wash
program in mid cycle, press the button. Any
water in the DishDrawer® will be pumped out.
Start/Pause button
The button starts a wash program. Press the button to pause or restart the
DishDrawer® during a wash program. When paused, wait for three beeps before opening the
drawer. Forcing the drawer open while in mid cycle may cause damage or injury.
Delay Start
The button also sets the Delay Start feature which can delay the start of a wash program
from 1 to 12 hours. This feature also satisfies Shabbat requirements if the Auto Power option is
disabled (see Option Adjustment).
To activate Delay Start
1 Pressandholdthe button until the light above the button turns orange (or purple
depending on your model).
2 Continue holding the button down until the desired delay time has been reached. The
DishDrawer® will emit audible ‘beeps’ as you hold the button down, each beep indicates
another hour delay.
3 The DishDrawer® will start once the delay time has elapsed and the drawer is closed.
To cancel Delay Start
Press the button.
Lock button / (optional)
The /button activates/deactivates the Keylock or the Childlock functions.
Keylock
The Keylock feature disables all the buttons on the DishDrawer®.
To activate, press and hold the /button until you hear one beep (3 seconds). The light
above the /button is lit when Keylock is activated.
To cancel the Keylock feature, press and hold the /button until the light above the
/button disappears.
Integrated badge
Prefinished models with no LCD
All manuals and user guides at all-guides.com

3
Childlock
The Childlock feature locks the drawer and disables all the buttons.
To activate, press and hold the /button until you hear two beeps (5 seconds). The light
above the /button is lit when Childlock is activated.
To cancel the Childlock feature, press and hold the /button until the light above
the /button disappears.
Wash program selector
Press the button to select a wash program. The DishDrawer® will remember the last
program used.
Eco button (optional)
Press the button if you would like the wash program to use less energy and time. The red
ECO light will indicate the feature is on. If your dishes are heavily soiled or you require enhanced
dry performance, we do not recommend ECO programs.
Power failure
If the DishDrawer® is operating and a power failure occurs, it will stop. The DishDrawer® may be
unable to be opened during this time. When the power supply is resumed, the DishDrawer® will
restart in the same part of the wash program.
All manuals and user guides at all-guides.com

4
LCD screen controls (Prefinished models with LCD)
If you have a double DishDrawer®, each drawer has its own control panel and can run
independently of the other.
Power Button
The button turns the DishDrawer® on or off. Opening the drawer will automatically turn the
DishDrawer® on for 30 seconds. To end a wash program in mid cycle, press the button. Any
water in the DishDrawer® will be pumped out.
Start/Pause Button
The button starts a wash program. Press the button to pause or restart the
DishDrawer® during a wash program. When paused, wait for three beeps before opening the
drawer. Forcing the drawer open while in mid cycle may cause damage or injury.
Delay Start
The button also sets the Delay Start feature which can delay the start of a wash program
from 1 to 12 hours. This feature also satisfies Shabbat requirements if the Auto Power option is
disabled (see Option Adjustment).
To activate Delay Start
1 Pressandholdthe button until the delay symbol appears on the electronic display.
2 Continue holding the button down until the desired delay time has been reached.
3 The DishDrawer® will start once the delay time has elapsed and the drawer is closed.
To cancel Delay Start
Press the button.
Lock Button (optional)
The button activates/deactivates the Keylock or the Childlock functions.
Keylock
The Keylock feature disables all the buttons on the control panel.
To activate, press and hold the button until you hear one beep (3 seconds). The symbol
appears in the electronic display when the Keylock feature is activated.
Wash program progress
symbol
Time remaining
(Delay Start)
Power button
Electronic display
(LCD screen)
Start/Pause button
Lock button
Delay Start symbol
All manuals and user guides at all-guides.com