Installing Trim Kit
Guide to Installing the Trim kit
1. Cut opening in the cabinet face per the following
dimensions:
Height: 19-3/16” + 1/16”, –0
Width: 25-3/4” + 1/16”, –0
Note: Refer to diagram on the
following page. The minimum
cabinet depth is 20”. When
installing the Microwave and
Trim Kit in combination with a
Wall Oven or Warming
Drawer, please follow the
recommendations in the
Microwave Installation/ Use &
Care Manual.
2. Add adequate platform base support in the bottom
of the cabinet for trim kit base to rest on.
3. Mark a centerline on the front edge of the cabinet
bottom (Fig. 05).
4. Place trim kit base and align centerline mark to the
triangular notch on the front edge of the base (Fig.
06).
5. Drill 1/8” pilot holes in the cabinet using the base
as a template and install a screw through the base
into the cabinet to prevent the base from shifting
(Fig. 07).
6. Insert Microwave into opening on top of the base.
The Microwave feet should sit in the recesses on
the base for correct alignment. The Microwave
Fig. 05
Fig. 06
https://producthelp.fisherpaykel.com/us/Cook/Microwave_Ovens/CMOTTK-FP/Installation_Guide_CMOTTK-FP/02_installing_…
Updated: Sun, 22 Jan 2023 11:51:13 GMT
Powered by
1
