Fisher-Price HHB63 User manual

OWNER’S MANUAL
HHB63

2
BEFORE YOU BEGIN
IMPORTANT!
Keep this instruction sheet for future reference, as it contains
important information.
Before assembly and each use, inspect this product for damaged
hardware, loose joints, missing parts or sharp edges. Do not use the
product if any parts are missing, damaged or broken. Do not use
accessories or replacement parts other than those approved by the
manufacturer. Never substitute parts.
Adult assembly is required. Tool needed for assembly: Phillips screwdriver
(not included).
Please read these instructions before assembly and use of this product.
Product features and decorations may vary from images.
Set aside at least 20 minutes for assembly.
One D (LR20) alkaline battery is required (not included).
For longer life, use alkaline batteries.
Use the product from birth until child weighs 18 kg (40 lb).
20
x1
1,5V
D
(LR20)

3
WARNING
FALL HAZARD: Children have suffered head injuries falling from rockers.
• ALWAYS use restraints until child is able to climb in and out of the product
unassisted. Adjust to fit snugly.
• NEVER lift or carry child in rocker.
• STOP using rocker when child has reached 40 lb.
• The upright position is only for children who have developed enough upper body
control to sit up without tipping forward.
• ALWAYS place rocker on floor. Never use on any elevated surface.
SUFFOCATION HAZARD: Children have suffocated when seats tipped over on
soft surfaces.
• NEVER use on a bed, sofa, cushion, or other soft surface.
• Stay near and watch child during use. This product is not safe for unsupervised
use or unattended sleep.
• The toy bar is not a carry handle. Never use toy bar to lift or carry product.

4
PARTS
M4,5 x 25 mm Screw
M5 x 30,5 mm Screw
x 6
x 2
NOTE: Tighten or loosen all screws
with a Phillips screwdriver. Do not
over-tighten the screws.
IMPORTANT! Please remove all parts from the package and identify them before assembly.
Some parts may be packed in the pad.

5
ASSEMBLY
1
2
3
x 2
Turn the assembly around and fit
it to the other side rail.

6
4
x 2
x 2
6
5
Turn the assembly around and fit the ends of the crossbar
to the pegs on the side rails.
ASSEMBLY

7
x 2
7
8
9
Turn the assembly face
down to fit the kickstand
to the side rails.
Turn the assembly upright.
After assembling the seat
back tube, pull up on it to
be sure it’s secure!
ASSEMBLY

8
10
11
12
ASSEMBLY

9
13
14
After assembling the pad,
push down in the seat
area to be sure it’s secure
to the frame!
The toy bar is removable.
Simply press the ends of
the latches and lift the
toy bar.
ASSEMBLY

10
BATTERY INSTALLATION
The battery compartment is located on
the inside of one of the side rails.
Loosen the screw in the battery
compartment door and lift to remove
the door.
Insert one D (LR20) alkaline battery.
Replace the battery compartment door
and tighten the screw.
Protect the environment by not disposing of this product or any batteries with
household waste. This symbol indicates that this product shall not be treated as
household waste. Check your local authority for recycling advice and facilities.