Fisher-Price M7935 User manual

M7935
M7935
www.fisher-price.com.au
www.fisher-price.com.au
IMPORTANT! KEEP
INSTRUCTIONS FOR
FUTURE REFERNCE.
WARNING

Important!
To prevent strangulation with power cord, never
place transmitter within reach of child.
WARNING
This product cannot replace responsible
adult supervision.
CAUTION
2

• For proper setup and use, please read these instructions.
• Please keep this instruction sheet for future reference, as it contains important information.
• Transmitter operates on AC current.
• Receiver operates on AC current (use enclosed AC adaptor) or three “AAA” (LR03) alkaline batteries
(batteries not included).
• Adult assembly is required.
• Tool needed for battery installation: Phillips screwdriver (not included).
•
This product is not intended to be used as a medical monitor and its use should not replace adult supervision.
• Test sound reception of receiver before first-time use and whenever you change location of transmitter.
• To prevent entanglement:
- Never place transmitter in a crib or playpen. Keep transmitter and receiver out of baby’s reach.
- Never use extension cords with the AC adaptor.
• Never use transmitter or receiver near water (ie.: bathtub, sink, laundry tub or wet basement, etc.).
• Always use transmitter and receiver where there is adequate ventilation. To prevent overheating, keep
transmitter and receiver away from heat sources such as radiators, heat registers, direct sunlight, stoves,
amplifiers, or other appliances that produce heat.
• Fisher-Price®does not recommend the use of two monitors in one house.
• Always remember that you are using public airwaves when using your monitor. Conversations, even from
rooms near transmitter, may broadcast to other nursery monitors, radios, cordless telephones, or scanners
outside your home. To protect privacy of your home, always turn transmitter off when not in use. Carrier
Frequency: 49 Mhz
Field Strength: 73.4dBuV/m at 3m
• Product features and decoration may vary from photos.
Important!
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121
Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
3

1
2
3
4
6789
10
5
11
12
13
Features
1Transmitter
2Power Indicator
3Microphone
4Power Button
5Night Light – press to turn on a soft glow.
6Channel Switch
7Receiver
8Speaker
9
On/Off/Volume Dial – Turns power on.
Set volume to a comfortable level.
10
Clip - (backside of receiver). Fasten
to your clothes to stay in touch with
baby around the house or yard.
11
Sound Lights - let you see
baby’s sounds.
12 Power/Low Battery Indicator
13 Channel Switch
4

Assembly
• Fit each antenna into the socket in the receiver and the transmitter. Turn the antennas to secure in place.
IMPORTANT! This product is designed to operate properly with the antennas provided. To reduce the chance
of potential radio interference to other users, assemble and use only the antennas provided.
Antenna
Antenna Antenna Antenna
Receiver Battery Installation (Optional)
Battery Compartment Door
Battery Compartment Door
• Locate battery compartment door on back
of receiver.
• Loosen screws in battery compartment door
with a Phillips screwdriver. Remove battery
compartment door.
• Insert three “AAA” (LR03) alkaline batteries
into the battery compartment.
• Replace battery compartment door. Tighten
screws with a Phillips screwdriver.
"AAA" (LR03)
1,5V x 3
5

In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
•
Remove batteries during long periods of non-use. Always remove exhausted batteries from the product.
Dispose of batteries safely. Do not dispose of this product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removeable, rechargeable batteries are used, they are only to be charged under adult supervision.
Battery Safety Information
Test transmitter transmission and receiver reception each time you change location of use.
• Place transmitter in room in which you intend to use it.
• Press transmitter power button to turn power on. Power indicator lights.
• Set transmitter channel switch to same channel as receiver. Turn on a radio.
Power Button
Power Button
Testing Sound Reception
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A M7935pr-0729
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
6

• Place receiver in room in which you intend to use it.
• Turn on/off/volume dial to turn power on. Power/low battery indicator lights. Adjust receiver location for
best reception.
Hint: If battery power is low, the power/low battery indicator turns orange. Replace batteries with three,
new alkaline “AAA” (LR03) batteries or use AC adaptor for power source.
On/Off/Volume Dial
On/Off/Volume Dial
Power/Low Battery
Indicator
Power/Low Battery
Indicator
Testing Sound Reception
7

• Sound lights turn on when sound is received by a receiver.
- One or two lights for shallow sounds
- Three or more lights for louder sounds.
• If you experience interference (buzzing or static, etc.) while using one channel setting, switch all units to
other channel. Selecting a channel is usually a one time adjustment.
Hint: You will see all five sound lights:
- I
f you turn receiver power on before transmitter power. You will also hear static noise. Turn volume down
and turn transmitter power on.
- If the receiver is too far away from the transmitter. Move the receiver closer to the transmitter.
- If loud sounds are transmitting.
Testing Sound Reception
Adjust Channel
8

IMPORTANT! Test sound reception of this monitor before first time use and whenever you change location
of transmitter (see page 6).
• Set transmitter channel switch to same channel as receiver.
Adjust Channel
Setup & Use
• Place transmitter in same room with child. Point microphone directly toward crib or play area.
• Unwrap and fully extend power cord for best transmission. Plug power cord into wall outlet.
• Use the power cord only in a wall outlet. Do not plug the power cord into a ceiling light.
• Press transmitter power button to turn power on.
• Press night light on transmitter for a soft, glowing light. (Press again to turn off night light.)
9

• Place receiver where you will see or hear it.
• Unwrap and fully extend AC adaptor cord for best reception. Insert AC adaptor jack into receiver socket
and plug into wall outlet.
Note: To use batteries as a power source, refer to instructions on page 5.
• Rotate receiver on/off/volume dial to turn power on. Power/low battery indicator lights. Rotate on/off/
volume dial to adjust volume.
Set & Use
• Clip to your clothes to stay in touch with baby around your house or yard.
Hint: Under permitting conditions, the receiver receives sounds up to 120 meters away from baby!
10