Flash ID-4 User manual

IMPORTANT!
This manual provides all the necessary information for your product to be properly and safely installed.
Please read all instructions before installation, and make sure you follow them carefully during the
installation process. Failure to follow these instructions may result in DAMAGE to the product or vehicle,
and/or SERIOUS INJURY to you and your passengers!
NOTE: Do not install and/or operate this product unless you have read and understand all the safety information and instructions contained in this
manual.
Functions and Programming
Installation Manual:
ID-4 4 Key Compact Controller
- Push the buon for 5 second to set as momentary switch.
- Push the buon for another 5 second to set as momentary switch.
Momentary Switch Programming
Function
To set function buttons as momentary switch
Default
All buons are default as ON/OFF Buon
P1
P2
P3
P4
Wiring
Diagram
Button Function Amp
Red - Positive -
Black - Negative -
Yellow P1 Output 0.2A
Blue P2 Output 0.2A
Purple P3 Output 0.2A
White P4 Output 0.2A
Product Code ID-4
Voltage 10-30 VDC
Output 0.2Amp per cable
IP Rang IP65
Dimension 38mm X 75.8mm X 23.8mm
Opons
- Adjustable Arm Mount
- Motorcycle Handle-Bar Clamp
Installation
Attach and secure the controller onto the panel stand. Place the device onto a
clean desired surface, where it can be easily accessible to the user. Use the
attached adhesive pad* to secure the device onto the surface. Should you
wish to remove / re-locate the controller, you may use alcohol or similar
cleaning formula to remove the left-over adhesive residue.
* The supplied adhesive pad is designed for one time use. You may replace it
with other double side adhesive tapes.
Adjustable Arm Mount
- 1 -

Manufacturer Limited Warranty Policy: Manufacturer warrants that on the date of purchase this product. This Limited
Warranty extends for Thirty Six (36) months from the date of purchase.
DAMAGE TO PARTS OR PRODUCTS RESULTING FROM TAMPERING, ACCIDENT, ABUSE, MISUSE, NEGLIGENCE, UNAPPROVED
MODIFICATIONS, FIRE OR OTHER HAZARD; IMPROPER INSTALLATION OR OPERATION; OR NOT BEING MAINTAINED IN
ACCORDANCE WITH THE MAINTENANCE PROCEDURES SET FORTH IN MANUFACTURER’S INSTALLATION AND OPERATING
INSTRUCTIONS VOIDS THIS LIMITED WARRANTY.
Installation
Attach and secure the controller onto the panel stand. Place the device onto a
clean desired surface, where it can be easily accessible to the user. Use the
attached adhesive pad* to secure the device onto the surface. Should you
wish to remove / re-locate the controller, you may use alcohol or similar
cleaning formula to remove the left-over adhesive residue.
* The supplied adhesive pad is designed for one time use. You may replace it
with other double side adhesive tapes.
Installation
- Secure clamp mount part #3 onto the controller.
- Use the supplied screws to secure clamp mount part #1 and #2
onto your desire mounting location. Use the supplied rubber pad
to help adjusting the grip and size of the mount.
- Insert clamp mount part #3 into part #2.Adjust the angle and
tighten the part.
Motorcycle Handle-Bar Clamp
1
2
3
- 2 -