Fleetwood M30Al User manual

Office
Phone: [phone]
Fax: [phone]
Warehouse
Phone: [phone]
Fax: [phone]
www.skyfood.us[email protected] -
TOLL FREE 1-800-503-7534
UG0123 - August /2011
Instructions Manual
Planetary Mixer
Model
M30A

SUMMARY
1-
2-
3- ACCESSORIES
4-
5- OPERATION
6-
INSTALLATION
COMPONENTS IDENTIFICATION
IDENTIFICATION
THECHNICAL SPECIFICATION
GENERAL SAFETY PRACTICES
1
1
1
1
3
4

01
IMPORTANT SAFEGUARDS
M30A Mixers complies with all safety requirements of UL
standards for commercial kitchen equipment & Canadian standards for
Canada.
M30A mixers complies with NSF.
1-INSTALLATION
1-Unpack unit, accesories and instructional material carrefully.
2-Check over equipment to make sure that there is not any
damage to equipment.
Note:If equipment oppears to be damge contact carrier within days from
delivery.
3-Please read all instruction carefully before operating equipment.
4-Find a suitable operating area to install equipment.
Note: Moke sure there is adequate space around equipment to allow the
user to properly operate controls and remove and install accesssories.
Do not place machine in wet or damp area.
5-Lift equipment off of the floor to move, do not slide equipment
across the floor.
Note: Do not handle or lift equipment alone; use the help of others.
6-Consult an electrician to assure the electrical supply complies
with specified current (amp) capacity.
7-Do not plug in the same outlet shared by other equipment.
8-Do not use extension cord.
9-Keep all accessories clean and in a safe place so they do not
become scratched or misplaced.
10-Do not expose the equipment to any moisture that may enter
electrical box or components.
11-For safety purposes, do not remove any service covers, safety
guards or warning labels.

02
2- COMPONENTS IDENTIFICATION
PICTURE-01
1-Stop Button- push to stop/turn to release
2-Start Button- push to start
3-Speed Control- controls the mixing speed
4-Top Cover
5- #12 Meat Grinder Attachment Hub- remove safety cover from #12 hub
to attach accessory.
6-Mixing Shaft- mixing accessories are attached to the mixing shaft
7-Safety guard- must be in close position during operation
8-Bowl- holds mixing contents
9-Base- rubber protection on bottom to prevent rusting, scratching and
sliding
10-Power cord - plug into current compliant electrical outlet
11-Bowl locks- secure bowl in place
12-Operation safety Switch- engages when bowl is raised & locked into
place.
13-Bowl lever- raises and lowers bowl.
This product will be replaced or repaired under warrant y, for a period of (1) year,
beginning from the date of purchase by the original purchaser/user (“End User”), or
eighteen (18) months from the date of shipment from SKYFOOD’s ware house,
whichever expires first.
Accessories will be re placed o r repaired under wa rranty, for a period of (30) days,
beginning from the date of purchase by th e original purchaser/user (“En d User”), or
eighteen (18) months from the date of shipment from SKYFOOD’s warehouse, whichever
expires first.
This warranty shall not take effect until a properly completed and executed WARRANTY
REGISTRATION form has been received by SKYFOOD EQUIPMENT, LLC, within thirty
(30) days from the da te of purch ase. The WARRANTY REGISTRATION is available either
in the Instruction Manual of every Product or at SKYFOOD’s website www.skyfood.us. The
End User must fill out the WARRANTY REGISTRATION form and send it to SK YFOOD
according to the instructions posted on the referred website. Failure to do so will VOID
the warranty.
No extended warranties for third party products. There are no other express
warranties or conditions othe r than the one offered by each manufacturer for
products sold by SKYFOOD, not under the FLEETWOOD by SKYMSEN and
SKYMSEN brand.
For questions or assistance, do not return the product or accessories to the store, please
call Toll Free 1-800-503-7534, or visit the Customer Service section at www.skyfood.us.
For faster service please have the items name, serial number, and proof of purchase for
the operator to assist you.
SKYFOOD reserve s the right to change the terms of its limited warranty at any time
without any prior notice. It also reserves the right to change the design and
specifications of its equipment or any related documentation at any time. The e nd
user is not entitled to upgrades or refunds resulting from these changes.
Updates
These Terms and Conditions were last updated on January 14th, 2014.

03
3- ACCESSORIES IDENTIFICATION
1-Bowl- 30qt. Mixing bowl
2-Dough Hook- suitable for mixing flour in low speed mode
3- Flat Beater- suitable for mixing crushed powdered in medium speed
mode
4-Wire Whisk- suitable for mixing liquids in high speed mode
5-Meat Grinder- optional attachment- suitable for grinding meat.
1) Bowl (30qt. Mixing bowl)
2) Dough Hook (to use
for mixing four) in low
speed mode
3) Flat Beater ( to use
for mixing crushed
powered) medium
speed.
4) Wire Whisk
(suitable for mixing
liquids) high speed
5) Meat Grinder
( optional )
SKYFOOD EQUIPMENT LLC - SERVICE
For questions o r assistance, call SKYFOOD EQUIPMENT Toll Free: 1-800-503-7534, or
visit the Customer Service section at www.skyfood.us.
SKYFOOD’S LIMITED WARRANTY
Unless otherwise specified,new FLEETWOOD by SKYMSEN and SKYMSEN products,
excluding accessories, sold by SKYFOOD EQUIPMENT, LLC. (“SKYFOOD”), for use only
in the continental United States (collectively, “Products” or singularly, “Prod uct”), are
warranted to be free from defects in materials an d workmanship for a period of one (1)
year from the date of purchase by the original purchaser/user (“End User”), or eighteen
(18) months from the date of shipment from SKYFOOD’s warehouse, whichever expires
first. Several new products and accessories may be warranted for a p eri od o ther than one
(1) year while others may be subject to travel limitations, as spe cified on the products
Instruction Manual. Proof of purcha se must be presented; if not this warra nty will be
VOID. No warranty is given or implied to a subsequent transferee or any other third party.
This warranty is expressly conditional up on SKYFOOD being notified of any defects in
materials or workmanship within five (5) days of its occurrence, wi thin the warranted time
period. If a notice of a claim under this warranty is timely made by the End User,
SKYFO OD or a SK YFOOD’s designated service company (“Service Company”), will rep air
or replace the Product, at SKYFOOD’s discretion, subject to the a dditional conditions
hereinafter described.
This warranty shall not apply if damage occurs from improper installation or maintenance
performed b y an unauthorized service company (“Service Company”), wrong voltage, nor
to the extent that Products or parts have been used other than in conformance with
operating and maintenance instructions, subjected to misuse or abuse or damaged by
accident, acts of God, abnormal use, stress or any other matter unrelate d to SKYFOOD,
and beyond its reasonable control. This w arranty does NOT cover service labor and
trave l to perform adjustments on products and/or accessories. In addition to wear and
tear of certain items, such as, but not limited to; glass parts, blades, stones, ch opper
cutting knives, plates, slicing knives, cutting disc, gaskets, oil changes, sealing tape, heat
seal wires, worm gears, self-lubricating bushings, carbon brushes for electric motors, a nd
other parts expendable by nature and that nee d to be replaced frequently. Electrical
components are subject to natural wear and tear, and are NOT covered by this
warranty. THIS WARRANTY EXCLUDES ALL ORAL, STATUTORY, EXPRESS OR
IMPLIED WARRANTIES WHICH MAY BE APPLICABLE TO SKYFOOD, INCLUDING,
BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY AND
FITNESS FOR PARTICULAR PURPOSE. Under no circumstances shall SKYFOOD be
liable for loss of use, re venue or profit or for incidental or consequential damages.
SKYFO OD shall un der no circumstances be liable for any loss, damage, concealed
damage, expense or d ela y of goods for any reason when said goods are in the custody,
possession or con trol of third parties selected by SKYFOOD to forward, enter, clear,
transport, or ren der other services with respect to such goods. The sole and e xclusive
remedy for breach of any warranty is limited to the remedies provided in the paragra ph
above.
All products held at non-commercial facilities o r domiciles, mu st be taken or shipped,
shipping charges prepaid, either to SKYFOOD's facility or a SKYFOOD's designated
service company ("Service Company"). Products held at commercial facilities and weighing

SAFETY PROCEDURES AND NOTES BEFORE SWITCHING ON
IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.
Be sure to be familiar with the instructions and that you have well understood all
information contained in this manual. If you have any question contact your
supervisor or your nearest Dealer.
Danger
An electric cable or electric wire with damaged jacket or bad insulation could
cause electrical shocks as well as electrical leak. Before use, check conditions of all
wires and cables.
Advices
Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood.
Every function and operational procedure have to be very clear to the operator.
Contact your nearest Dealer for further questions.
Any manual command (switch, button or lever) shall be given only after being
sure it is the correct one.
Precautions
The electric cable has to be compatible with the power required by the machine.
Cables touching the floor or close to the machine need to be protected against short
circuits.
AFTER THE WORK ENDS
Cares
Always clean the machine, to do the cleaning SWITCH IT OFF, AND TAKE
OUT THE PLUG FROM THE ELECTRICITY SUPPLY SOCKET .
Never clean the machine BEFORE IT IS COMPLETELY STOPED.
Fit all the machine components in their due places, before switching it on
again.
MAINTENANCE
Dangers
Any maintenance is dangerous if made with the machine switched on.
SWITCH IT OFF AND TAKE OUT THE PLUG FROM THE SOCKET, DURING
ALL THE MAINTENANCE OPERATION.
IMPORTANT
In any emergency situation, always take the plug out of its socket.
CEADVI S
e t c lrc a i mt n eb u ie es n .
El c ri ao me h n cal ain ena c shall e made by q alif d p r o s
s n in cam t n n e prel h c mwsThe per o hrge of the ain e a c eformanc s shal c e k the achine ork
OLF Y D T O .under T TASA ET CON I I NS
05
4- THECHNICAL SPECIFICATION
Note: Select speed according to specified accessory
mode.
A) Dough Hook- Suitable for mixing flour and bread dough on
the low speed mode.
Note: Mix should equal 45% to 50% of the folur weight ( See
Figure G)
B) Flat Beater- suitable for mixing crushed, powdered and
pasty food, sush as stuffing on medium speed mode ( See
figure H )
C) Wire Whip- suitable for mixing liquid food, sush as cream,
egg on high spped mode ( See figure I ).
Model
M30Al
Bowl
Volume
30qt
Motor
1 phase
Frequency
60 Hz
Power
2hp
Mixing speed
65/102/
196 rpm
Maximum
Kneading capacity
22 lb/hr
Dimensions
24”x21”x40”
Net
Weight
425lb

6-General Safety Practices
The following safety instructions are addressed to both the operator of the
machine as well as the person in charge of maintenance.
The machine has to be delivered to the operator in perfect conditions of use by
the Distributor to the user. The user shall operate the machine only after being well
acquainted with the safety procedures described in the present manual. READ THIS
MANUAL WITH ATTENTION.
Basic Operation Practices
Dangerous parts
Some parts of the electric devices are connected to high voltage points.
These parts when touched may cause severe electrical shocks or even be fatal.
Never touch commands such as buttons, switches and knobs with wet hands, wet
clothes and/or shoes. By not following these instructions operator could be exposed to
severe electrical shocks or even to a fatal situation.
Warnings
The operator has to be well familiar with the position of ON/OFF Switch to make
sure the Switch is easy to be reached when necessary. Before any kind of maintenance,
physically remove plug from the socket.
Provide space for a comfortable operation thus avoiding accidents.
Water or oil spilled on the floor will turn it slippery and dangerous. Make sure the floor is
clean and dry.
Before giving any manual command (switch, buttons, turn keys or lever) be sure
the command is the correct one. Check this manual for further details if necessary.
Never use a manual command (switch, buttons, lever) unadvisedly.
If any work is to be made by two or more persons, coordination signs will have to be given
for each operation step. Every step of the operation shall be taken only if the sign has
been made and responded.
Advices
In case of power shortage, immediately turn the machine OFF.
Use recommended or equivalent lubricants, oils or greases.
Avoid mechanical shocks as they may cause failures or malfunction.
Avoid penetration of water, dirt or dust into mechanical or electrical components
of the machine.
DO NOT modify original characteristics of the machine.
DO NOT remove, tear off or maculate any labels stuck on the machine. If any
label has been removed or is no longer legible, contact your nearest dealer for
replacement.
IMPORTANT
If any item from the GENERAL SAFETY NOTIONS section is not applicable to
your product, please disregard it.
04
5- OPERATION
1.Make sure the equipment is properly installed.
2.Attach accessory suitable for mixing needs to mixing shaft 6.
Note: Be careful not ot scratch or damage the mixing bowl 8
when assembling accessories.
3.Secure the bowl using the bowl locks 11 on both sides of
bowl.
4.Pour contents into mixing bowl 8.
5.Turn bowl lever 13 clockwise into locked position.
Double check that all steps have been completed
6.Close safety guard 7.
7.Turn speed switch to suggested speed for intended use 3
Note: For safety purposes, stop unit before changing speeds.
8.Make sure stop button 1 is released.
9.Plug in power cord 10.
10.Press start button 2.
11.Before checking contents, pres stop button 1.
12.Open safety guard 7 to check contents.
Note: A safety feature will turn off the machine if it is
overloaded. If this occurs please wait a few minutes.
13.This unit can work in the #12 mincer attachment. If the user
want it, please point out especially, and pay for it.