Flex Court FleXtreme Series User manual

FLEX COURT INTERNATIONAL, INC
FleXtreme Series Installation Guide
“Delivering Ultimate Performance in Sports”

Tools You Will Need:
-Level
-Crescent Wrench (2)
-Phillips head Screw Driver
-9/16 Socket
-Rubber Mallet
-Shovel
-Wheelbarrow
-Gardening Hoe
Parts Included with FleXtreme Hoop Systems:
1) Base Pole and Backboard
1) Pier Kit Plate, 4 Jbolts, and Rebar
1) Lower Extension Arm
2) Upper Extension Arms
1) Crank
2) Pistons with 872A and 672A, 1) Piston with 560A and 454A
4) Backboard Bushings
1) Safety bracket and Pin
3) 16mm x 11” Bolts and Nuts, 1) 18mm x 11” Bolt and Nut, 2) 16mm x 10” Bolts and Nuts,
1) 14mm x 5” Bolt and Nut, 1) 14mm x 4.5” Bolt and Nut
1) Plastic Height Indicator and Sticker
1) Rim with hardware, Net and Rim Plate Cover

Build Pier Kit by threading 1 Nut on Jbolts, next put the pier kit plate on top of that nut and
then fasten nut on top of the plate, as shown and Place in concrete to bottom of base plate
and let sit min 4-5 days before proceeding to next step
Mount Pole on top of Jbolts, Level and use Locking Nuts to tighten
down pole

Attach Lower Extension Arm with 16mm x 11” Bolt and Nut.
NOTE: Use the First Set of Holes on the extension arm
Next line up the bottom holes of the pistons and fasten them with the 14mm x 5”
Bolt and Nut

Tip: When connecting the top of the pistons, if the holes don’t
line up, use a bolt to spin the tops so they line up as shown
Pull the arm up and use the 18mm x 11” bolt and connect the
pistons as shown

Adjust the Crank up to match the holes and fasten the
crank down with the 16mm x 11” bolt and Nut
Connect the Bottom of the crank with the 12mm x 4.5” Bolt and
Nut

Crank the Lower arm down with the crank and attach the upper
extension arms using the 16mm x 10” Bolt and Nut
Attach the backboard by raising it up and use a 16mm x 11” bolt to
attach the lower extension arm to the lower connection point on the H
Bracket

Bring up the backboard and attach the Upper Extension Arms using
the 16mm x 10” bolts to the upper connection point on the H Bracket
Put in the 4 Backboard Spacers

Line up the Rim with using the rim hardware as shown
Tighten the rim with the washer, lock washer, and nut and fasten
the bottom bolts and nuts

Thread the Net through all the holes

Attach the tape measure to the to rim and crank the rim
up till the tape measure reaches 10’ to ground level
Once you are at 10’ fasten the Plastic Height Indicator on the
piston bolt and place the sticker on the piston as shown so the
bottom of the plastic piece is at 10’

Enjoy your FleXtreme Hoop