Flexsolar C60 Guide

60W FOLDABLE SOLAR PANEL
60W FOLDABLE SOLAR PANEL
INSTRUCTION MANUAL & WARRANTY
MODEL C60
PN: FLC-C6-200600-4
CABLES INCLUDED:
1) 10’ (3M)
cable with
DC 5521 male
connectors
2) 4-in-1
interchangeable
connectors
3) 1’ (0.3M)
DC 5521 to
alligator clip
cable

2
Thank you for purchasing this FLEXSOLAR® product. Before operating, please read
these instructions carefully. This instruction manual contains information for safe
use and maintenance of the product.
Please keep this instruction manual in a safe place for future reference.
The manufacturer does not accept responsibility for any damages due to not
following these instructions.
TABLE OF CONTENTS
General
Safety Precautions for Using a Foldable Solar Panel
General Operation Notes
Pg. 02
Product Overview
60W Foldable Solar Panel
Cables
Pg. 04
Before Using
What’s in the Box
Pg. 07
Operation
Installation
Choose the location
System Connection
Pg. 07
Maintenance Pg. 09
Warranty Statement Pg. 10
GENERAL
Please carefully read the following operation and safety instructions. Non-compliance
with these instructions may void the product warranty.
This guide contains information regarding the operation and safe handling
FLEXSOLAR® solar panels and components. All operations must be read and
understood before attempting operation. If there are any questions, please contact
your dealer or FLEXSOLAR® customer support for further information.
The user should conform to all safety precautions in the guide when using solar
panels. Before using a solar photovoltaic system (including cable, power station
or other electric equipment), the user should be familiar with the mechanical and

3
electrical requirements for photovoltaic systems. Keep this guide in a safe place for
future reference.
• All solar panels come with permanently attached output ports. Your dealer can
provide additional extension cables to simplify module wiring.
• Exercise caution when wiring or handling solar panels exposed to sunlight.
• Photovoltaic solar panels convert light energy to direct-current electrical
energy and are designed for outdoor use.
• Solar panels may be hung, placed flat, or use provided kickstand to face
towards the sun.
• Do not frequently connect or disconnect wires attached to solar panels when
they are exposed to sunlight in order to extend panel service life.
• Do not attempt to disassemble the solar panel, and do not remove any
attached nameplates or components. Doing so will void the warranty.
• Do not apply paint or adhesive to the solar panel.
• Do not use mirrors or other hardware to artificially concentrate sunlight on the
solar panel.
Safety Precautions for Using a Foldable Solar Panel
• Solar panels produce electrical energy when exposed to sunlight.
• FLEXSOLAR® solar panels can be connected in series. When connected together
(either in series or parallel), make sure that each solar panel has the same
rated voltage. Your dealer can provide additional cables to simplify panel
connections.
• Observe the instructions and safety precautions for all other components used
in the system, including wiring, cables, connectors, and etc.
• Use only equipment, connectors, wiring, and mounting hardware suitable for
use in a photovoltaic system.
• Always use the same type of solar panel in a particular photovoltaic system.
• Under normal operating conditions, solar panels will produce currents and
voltages that may vary from those listed in the data sheet. Data sheet values
are applicable at standard test conditions only.
General Operation Notes
• Do not stand or step on the solar panel.
• Do not drop the solar panel or allow objects to fall on the solar panel.
• Do not place any heavy objects on the solar panel.

4
PRODUCT OVERVIEW
60W Foldable Solar Panel (FLC-C6-200600-4)
FLEXSOLAR® solar panels are made of monocrystalline solar cells in series with high
efficiency, high transmission rate, and anti-aging EVA. They are designed for easy use,
extended longevity, and portable operation.
Unfolded View of the 60W Foldable Solar Panel:
Folded View of the 60W Solar Panel:

5
Specifications
Maximum Power (Pmax) 60W
Max Power Voltage (Vmp) 19.8V
Max Power Current (Imp) 3.03A
Open Circuit Voltage (Voc) 23.7V
Short Circuit Current (Isc) 3.18A
Cell Efficiency 22%
Cell Type Monocrystalline
Power tolerance ± 10%
Temperature Co-efficient (Power) -0.45%/ °C
Temperature Co-efficient (Voltage) -0.32%/°C
Temperature Co-efficient (Current) +0.02%/ °C
NOCT (Air 20°C, Sun 0.8kW/m², Wind
1m/s)
45±2°C
Weight (Includes Accessory Items) 2.9kg/ (6.4lbs)
Operation Temperature -4°F to 149°F (-20°C to 65°C )
IP Rating IP65
Cables
• Passed conduction test, there was no short circuit, open circuit, dislocation, etc.
• Cables are free of dirt, scratches, damage, color difference or other defects.
• All materials meet RoHS environmental standards.

6
Specifications
Category Location Description Cable
Length
Wire
Specification
Remark
Output
Ports
From
junction
box
Suspension line of
USB 2.0
3’
(1000mm)
16AWG Connected
Type C (PD 60W) / / Built In
DC 5521
USB 3.0
LED Indicators
Accessories / Cable with DC
5521 male
connectors
10 ft (3 M) 16AWG /
4-in-1
interchangeable-
connectors
/ 16AWG
DC 5521 to
alligator clip cable
1 ft (0.3 M) 16AWG
Note: the specification of 4-in-1 interchangeable connectors is below

7
BEFORE USING
What’s in the Box
Make sure you have all the following items included in the package. If any item is
damaged or missing, contact your dealer.
• 1 x 60W Foldable Solar Panel
• 1 x 10’ (3M) cable with DC 5521 male connectors
• 1 x 4-in-1 interchangeable connector (7.9*5.9mm, 6.3*3.0mm, 5.5*2.5mm,
3.5*1.35mm);
• 1 x 1’ (0.3M) DC 5521 to alligator clip cable
• User Manual
OPERATION
Installation
1. Remove the product from the box.
2. Unfold the portable solar panel:
• Lift and lay flat the portable solar panel;
• Unfold the two sides of the panel.
3. Support the portable solar panel like the diagram below:
• Prop up the stands of the portable solar panel;
• Stand the panels with locked legs on a flat surface.
4. Adjust the face of the portable panel toward the sunlight.

8
Choose the location
• Choose a flat location to place the solar panel.
• Place the solar panel in an open location. Make sure the panel can be exposed
to the sun directly and avoid any shadow on the surface.
• Make sure the angle between panel and the sunlight is close to 90 degrees.
System Connection
• Connect the solar panel to the power station directly.
• Connect the power station to the electronic equipment, like phone, iPad, laptop
and so on.
Output Ports
LED Indicator
• Red Light – panel exposed to sun light
• Yellow Light - after connect electronic equipment to the type C output port
Note: The electronic equipment can also be charged using solar panel output ports:
USBs, DC port or Type-C, while there is no power station.

9
MAINTENANCE
• Clean the surface of the solar panel when needed. Always use a soft sponge
or cloth for cleaning. A mild, non-abrasive cleaning detergent may be used to
remove stubborn dirt. Don’t clean when the panel surface is hot.
• Clean solar panels more frequently during drier months, as they may become
covered in dust more quickly. A pressure washer is not recommended.
• Caution: Observe the maintenance instructions for all components used in the
system, such as support frames, charge controller, batteries, etc.

10
WARRANTY STATEMENT
FLEXSOLAR® warrants to the original consumer purchaser that the FLEXSOLAR®
product will be free from defects in workmanship and material under normal
consumer use during the applicable warranty period identified in the ‘Warranty
Period’ section below, subject to the exclusions set forth below. This warranty
statement sets forth FLEXSOLAR® total and exclusive warranty obligation. We will not
assume, nor authorize any person to assume for us, any other liability in connection
with the sale of our products.
Warranty Period:
The warranty period is 24 months. In each case, the warranty period is measured
starting on the date of purchase by the original consumer purchaser. The sales
receipt from the first consumer purchase, or other reasonable documentary proof, is
required in order to establish the start date of the warranty period.
Remedy:
FLEXSOLAR® will repair or replace (at FLEXSOLAR® option) any FLEXSOLAR® product
that fails to operate during the applicable warranty period due to defect in
workmanship or material. If a valid claim is made during the applicable period,
FLEXSOLAR®, at its option, will either (1) replace the product, or (2) exchange the
product with a product that is of equal value. A replacement product assumes the
remaining warranty of the original product or 60 days from the date of replacement,
whichever is greater. Customer is responsible for the return shipping costs.
Limited to Original Consumer Buyer:
The warranty on FLEXSOLAR® products is limited to the original consumer purchaser.
Exclusions:
FLEXSOLAR® warranty does not apply to (I) any product that is misused, abused,
modified, damaged by accident, or used for anything other than normal consumer
use as authorized in FLEXSOLAR® current product literature, or (II) any product
purchased through an online auction house.

11
How to Receive Service:
To obtain warranty service, you must contact our customer service team. If our
customer service team determines that further assistance is required, they will
give you a Return Material Authorization (“RMA”) number and will provide you with
return instructions. You must properly package the product, clearly marking the RMA
number on the package and including proof of your purchase date with the product.
We will process your return and send your repaired or replacement product to you in
continental North America.
Exclusive Remedy; Limitation of Liability:
The foregoing provisions state FLEXSOLAR® entire liability, and your exclusive remedy,
for any breach of warranty, express or implied.
IN NO EVENT WILL FLEXSOLAR® BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL
DAMAGES ARISING FROM ANY USE OR MALFUNCTION OF ANY FLEXSOLAR PRODUCT, OR
FROM ANY BREACH OF WARRANTY, INCLUDING DAMAGE TO OTHER DEVICES. IN NO EVENT
WILL FLEXSOLAR’S LIABILITY FOR ANY CLAIM, WHETHER IN CONTRACT, WARRANTY, TORT
(INCLUDING NEGLIGENCE AND STRICT LIABILITY) OR UNDER ANY OTHER THEORY OF LIABILITY,
EXCEED THE AMOUNT PAID BY YOU FOR THE FLEXSOLAR® PRODUCT.
Some states or provinces do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you.

INNOTECH ENTERPRISE LLC
Customer Support:
800-620-1249
[email protected]
flexsolarenergy.com
Innotech Enterprise LLC is a wholly subsidiary of Flextech Company.
FLEXSOLAR® is a registered trademark of Flextech Company.
®All rights reserved.
©2013-2024 FLEXSOLAR® is a trademark licensed for use by Flextech Company and
registered in the U.S.
M-FLC-C6-200600-4
Product Label: UPC code:
Serial Number:
785249 51914 7
White
Black
Program: Illustrator CC
NOTES:
1. THE DRAWING IS LAYER CONTROLLED.
- CONTENTS ON LAYER “NOTES”ARE FOR REFERENCE ONLY, DO NOT PRINT.
- ONLY CONTENTS ON LAYER “ART” & SHOULD BE PRINTED OUT.
2. MATERIAL: 2 MIL MATTE PET METALLIZED.
3. ADHESIVE: PERMANENT ACRYLIC BASED ADHESIVE WITH TEMPERATURE LIMIT ABOVE
130OC.
4. PRINTING AND COLORS TO BE PER FLEXTECH APPROVED ARTWORKS.
5. BLUE BOLDER IS DIECUT LINE, DO NOT PRINT.
Die-cut line, do not print out.
79 mm
100 mm
Model Type
Max Peak Power (P
max |W)
Maximum Power Point Voltage (V
mpp |V)
Maximum Power Point Current (I
mpp |A)
Open Circuit Voltage (V
oc |V)
Short Circuit Current (I
sc |A)
Normal Operating Cell Temperature (NOCT)
Temperature Range (
℃)
Power Tolerance
Application Class
Gross Weight kg/(lb)
Net Weight kg/(lb)
Dimensions (unfolded) mm/in
Dimensions (folded) mm/in
All technical data at Standard Test Condition (STC)
Standard Test Condition (E=1000W/m
2, Tc=25℃, AM 1.5)
FLC-C6-200600-4
60W
19.8V
3.03A
23.7V
3.18A
45℃
-20℃~65℃
±10%
Class A
3.4kg/(7.4lbs)
2.9kg/(6.4lbs)
849x711x5 mm/33.43x28x0.2 in
350x220x55 mm/13.8x8.7x2.2 in
Only qualified personnel should install or perform
maintenace work on these modules.
This unit produces electricity if exposed to light.
Follow all applicable electrical safety precautions.
Don’t disconnect when loading.
Don’t damage or scratch the suface of the modules.
WARNING ELECTRICAL HAZARD