MNTZ36W Wall Mount Bracket User’s Manual
Dimensions
Installation
Description
Accessories
□
□
- Aluminum & Steel body
- Unit : 1.4Kg
Part Name
SCREW 8x38 (SUS)
WASHER 6x20
WASHER 6x20 4EA
SEAL TAPE (12mm)
SCREW PH M4x8 (SUS)
RUBBER GASKET (SILICON)
Q'ty
4
4
1
4
1
No
1
2
3
4
5
SEAL TAPE
NOTE: Camera installation requires the M4x12 mounting screws supplied
with the camera. Make sure the o-rings are attached to the mounting screws
and dome cover torx screws to prevent water ingress.
Compatible with Digimerge Camera Models: DPZ36WO23 / DPZ36WO30
Compatible with Accessories: MNTZ36R (Corner Mount) / MNTZ36P (Pole Mount)
① Drill holes in the surface for the cables and mounting screws and
run the cables through the cable hole.
② Run the cables through the mount and attach the mount to the
surface using the 8x38 screws (4ea) and 6x20 washers (4ea).
Wrap seal tape around the thread at the bottom of the mount.
③ Insert the rubber gasket between the camera adapter and the adapter
flange and connect the adapter flange to the camera adapter using the
PH M4x8 screws (4ea). Run the cables through the camera adapter
assembly, and screw the camera adapter assembly onto the mount.
④ Install the camera into the camera adapter
(see instructions on back of sheet).
MS PH M4x8
SUS 4EA
RUBBER GASKET
ADAPTER FLANGE
CAMERA ADAPTER
#8x38 SUS 4EA
CABLE
CABLE
Usage Cautions and Warnings
Please read through the User Manual and all safety instructions prior to use.
•All the safety and operating instructions should be read before installing. Follow
all operating instructions.
•Installation must be performed by a trained professional.
•Do not use the product with cameras other than the recommended models.
•The mounting has to be installed onto a firm and stable location that can
support the weight of the camera and mount. Ensure all parts are completely secured.
•Do not use this product for other purposes
Product Characteristics
This product has been designed to be used in the installation of speed dome cameras. This product has been
fabricated using strong, corrosion-free aluminum alloy material.
Prior To Installation
Avoid installing the mounting onto an unstable structure such as a gypsum wall panel. Install the mounting onto a strong structure
such as a concrete wall, steel beam, etc. Use concrete screws with plugs or other installation tools when installing the mount onto
a concrete structure. Make sure that all the screw parts are metallic.
Avoid screwing too close to the edge of a piece of wood when screwing into a wooden structure.
□
