FLOS RF0303600 User manual

!
RF0303600
SWITCH DIMMER 400mA ASSEMBLY FOR OLD VERSION
FLOS U.S.A., Inc. 110 York Street, 5th Floor, Brooklyn, NY 11201 | Tel: [phone] | Email: [email protected] | http://usa.flos.com
This document is exclusive property of Flos S.p.A. and its affiliated companies.

!
WARNING! When installing and whenever acting on the appliance, ensure that the power supply has been
switched off. For the installation of the spare-part, it is necessary to consult a qualified electrician.
FLOS U.S.A., Inc. 110 York Street, 5th Floor, Brooklyn, NY 11201 | Tel: [phone] | Email: [email protected] | http://usa.flos.com
This document is exclusive property of Flos S.p.A. and its affiliated companies.
Unlock the plug (P) from the old version switch
dimmer (Q) by turning it 90° anticlockwise.

!
FLOS U.S.A., Inc. 110 York Street, 5th Floor, Brooklyn, NY 11201 | Tel: [phone] | Email: [email protected] | http://usa.flos.com
This document is exclusive property of Flos S.p.A. and its affiliated companies.
Insert the plug into the driver unit by using the
guides snap it inside its apposite slot (use the
correct type of plug for the area in which the
device must be installed), connect the plug to the
feeder unit locking it in by rotating it 90°
clockwise.
Assemble now the new spare-part:
Connect the plug (P) to the push button
switch (Q) locking it by turning it 90º
clockwise.

!
DIMMER SPECIFICATION SHEET
Attention!!! Dimensions in the present drawing are in mm.
FLOS U.S.A., Inc. 110 York Street, 5th Floor, Brooklyn, NY 11201 | Tel: [phone] | Email: [email protected] | http://usa.flos.com
This document is exclusive property of Flos S.p.A. and its affiliated companies.
Dc IN VOLT 12V-48V
Dc IN I 1 A
Dc OUT I 400mA

!
DIMMER WORKING PRINCIPALS
FLOS U.S.A., Inc. 110 York Street, 5th Floor, Brooklyn, NY 11201 | Tel: [phone] | Email: [email protected] | http://usa.flos.com
This document is exclusive property of Flos S.p.A. and its affiliated companies.
Push the button (Q) for switching on and off the light intensity.
DIMMING MODES:
•Step dimming. By pressing the push button the light
intensity will switch-on to the maximum light intensity,
pressing the button the second time the light intensity
will decrease to 50% pressing the button again Power
off.
•10%-100% Dimming. To adjust the intensity of the light,
keep pressed-down (long push) the push button until
reaching the desired intensity of light. Once the level has
been reached, release the button.
When the device is powered-OFF through the push button (Q),
the light intensity will not memorize the last level set. This
means that when powered back on, the light intensity will be

!
TECHNICAL DATA SHEET :: DATI TECNICI
Attention!!! Dimensions in the present drawing are in mm.
FLOS U.S.A., Inc. 110 York Street, 5th Floor, Brooklyn, NY 11201 | Tel: [phone] | Email: [email protected] | http://usa.flos.com
This document is exclusive property of Flos S.p.A. and its affiliated companies.