Focal Digital Wireless USB Transmitter User manual

Digital Wireless
USB Transmitter
User manual I Manuel d'utilisation

Digital Wireless USB Transmitter
User manual
Synchronization
button
m
synchronization LED
HOW TO ASSOCIATE ONE TRANSMITTER TO ONE
RECEIVER
1. If you are using the USB transmitter with a Mac. For
the first use, when your USB transmitter is plugged,
go on System Preferences I Sound and choose the
Focal Digital TX.
2. Activate the receiver synchronization mode: switch
ON the receiver, press and release the synchronization
button. The Sync.LED will quickly flash.
3. Activate the transmitter synchronization mode:
connect the transmitter to your computer, press du-
ring 3 seconds the synchronization button situated on

Digital Wireless
USB
Transmitter
User
manual
the
bottom
side
of
the
transmitter.
The LED
will
quickly
flash. Release
the
button.
Info:
As long as
the
LED of
the
receiver
and
trans-
mitter
flash
quickly
do
not
switch
OFF
the
receiver
or
disconnect
the
transmitter.
After
few
seconds,
both
devices
will
be
associated
and LED on
receiver
and
transmitter
will
flash
slowly.
This
procedure
permits
to
synchronize
a USB
trans-
mitter
to a
receiver
independently
from
the
computer
used.
You
can play
the
music
using
the
associated
USB
transmitter
from
your
computer
or
from
another
one
without
follow
the
synchronization
procedure
again.
One
transmitter
can be
associated
with
4
receivers
simultaneously.
Repeat
the
above
procedure
to
asso-
ciate a
new
receiver
.
HOW
TO
ASSOCIATE
ADDITIONAL TRANSMITTER
TO
ONE
RECEIVER
1.
Disconnect
all
the
transmitters
(iTransmitter
and
USB
transmitter)
already
associated
with
the
receiver.
2.
Repeat
instructions
1,
2 and 3
of
the
page
1.

Digital Wireless USB Transmitter
User manual
m
Several transmitters can be associated to one recei-
ver. Repeat the procedure to synchronize any extra
transmitter.
Use Instruction
With one receiver
<10m
Info: If the Pause key is pressed on the media player
software, it will turn OFF the USB transmitter. This
permits to free up the receiver and allow another
transmitter to be connected to it. Press Play on the
media player software to restore the transmission
between the computer and the receiver.

Digital Wireless
USB
Transmitter
User
manual
With
2 to 4
receivers
Info:
Only
one
receiver
can
play
at
one
time.
Each
time
you
make
a
quick
press
on
synchronization
button,
the
sound
is
getting
played on
the
next
associated
receiver.
Be
sure
the
receiver
is
ON
and
the
Wireless
input
is
selected
to
play
your
music.

Digital Wireless
USB
Transmitter
User
manual
[5]
GENERAL
CHARACTERISTICS
1.
Range
2. Rated
current
AUDIO
CHARACTERISTICS
1.
Sampling
Rate
2.
Resolution
RADIO
CHARACTERISTICS
1.
Frequency
Range
2.
Sensitivity
10m
(line
of
sight)
70mA
44.1kHz
16
bits
2.4GHz
ISM
band
87dBm

Digital Wireless
USB
Transmitter
User
manual
Digital
Wireless
USB
Transmitter
Model:
WTX
1
016
FCC 10:
WUO-WTX1
016
I.C.
7985A-WTX1
016
This
device
complies
with
Part
15
of
the
FCC Rules.
Operation
is
subject
to
the
following
two
conditions:
(1)
this
device
may
not
cause
harmful
interference,
and
(2)
this
device
must
accept
any
interference
received,
including
interference
that
may
cause
undesired
operation.

Digital Wireless USB Transmitter
User manual
Conditions of guarantee
m
All Focal products are covered by guarantee drawn
up by the official Focal distribut or in yo ur co unt ry.
Your distributor can provide all details concerning the
conditions of guarantee.
Guarantee cover extends at least to
that granted by
the legal guarantee in force in the country where the
original purchase invoice was issued.
Now it's possible to register on tine:
www.focal.com/warranty
Due to constant technological advances, Focal-JMlab® reserves its right to modify
specifications without not1ce.

-t
--
--
-
----
----
----
www.
focal.
com
© 2012 Focal-JMlab tous dro
it
s reserves. Fabrique en Chine.
Focal
est
une marque de Focal-JMlab.
©
2072 Focal-JMlab all rights reserved. Made
in
China.
Focal
is
a trademark ofFocal-JMlab.
SC
EB-120627/3 -co
do
1346