Focusrite Vocaster DM14v User manual

focusrite.com Tell the world 1
Introduction
The Vocaster DM14v is a dynamic microphone tuned for recording
broadcast, webcast and podcast-style studio-quality voices. It has
a smooth and wide frequency response along with an integrated
windshield for close-proximity recording situations.
The Vocaster DM14v includes:
• A built in windshield.
• Internal suspension and shock mount
• Built-in broadcast-style stand mount.
• A cardioid polar pickup pattern.
• 3m XLR cable
The Vocaster DM14v’s cardioid pickup pattern (See “Polar Pattern”
on page 3), its dynamic capsule, and built-in windshield mean
you can get close to your microphone to hear more of you and less
of your room, anywhere.
Dimensions
60mm
191mm
124mm
User Guide

focusrite.com Tell the world 2
Setup
Using DM14v with a microphone stand
The Vocaster DM14v has a built-in a microphone stand mount and a microphone stand
thread adaptor (inside the microphone stand mount). Microphone stand mounts come in
two standard screw sizes, Vocaster DM14v’s integrated mic stand mount has a removable
adaptor you can insert or remove to t your microphone stand.
Removable
adaptor
Microphone
pickup direction
Vocaster DM14v FAQs
Does the Vocaster DM14v need 48V (Phantom Power)?
No, the Vocaster DM14v is a dynamic moving coil microphone. This type of microphone
doesn’t need power to work.
Will the Vocaster DM14v be damaged by 48V (Phantom power)?
No, the Vocaster DM14v will not be damaged if you send it 48V phantom power
accidentally, or if you need to enable 48V for all channels on your interface.
How far should I be from the microphone?
Speaking close to the microphone reduces the effect of the room’s acoustics, but
increases the bass response. This can be good for some voices but for a more natural
sound, move away from the microphone slightly, about the length of a st (10-15 cm).
If the room you’re using doesn’t sound good, the further you are from the microphone,
the more you’ll hear the room sound when you listen to the recording. Natural room
reverberation is neither good or bad, but often inappropriate for voice recordings.
The microphone is quiet or sounds strange?
Make sure you’re speaking into the end of the microphone (see diagram), if the
microphone is still too quiet, try increasing the gain on your interface, speaking louder, or
getting closer to the microphone.
Can I use an XLR to jack cable with my microphone?
The Vocaster DM14v is designed for use with an XLR cable. An XLR to jack cable might
work but it’s likely to sound worse or not work.

focusrite.com Tell the world 3
SpecificationsSpecifications
Technical Specications
Capsule
Type Dynamic (Moving Coil)
Polar Pattern Cardioid
Performance
Sensitivity
(0dB = 1V/Pa at 1kHz) -57dB
Frequency Response 50Hz - 16KHz
Impedance (@1kHz) 200Ω
Physical Characteristics
Mounting Standard 5/8”; 3/8” adaptor supplied
Net Weight 655g (1lb, 7oz)
Body Dimensions Diameter 60mm
Length 191mm
Finish Matte Black/Red Trim
Output Connector 3-Pin XLR, balanced output
Pin 1 (Ground), Pin 2 (+), Pin 3 (-)
Frequency Response
A microphones frequency response chart shows how sensitive a microphone is across the
audible frequency range for human hearing. We’ve designed Vocaster DM14v’s frequency
response for studio-quality voice recordings.
20
20 50 100 200 500 1K 2K 5K 10K
20K
10
0
-10
-20
-30
dB
Hz
Polar Pattern
The polar pattern shows how sensitive the microphone is in the areas around the
microphone. The angle 0° refers to speaking into the end of the Vocaster DM14v.
10,000 Hz
1,000 Hz 5,000 Hz
0˚
30˚
60˚
90˚
120˚
150˚
180˚
210˚
240˚
270˚
300˚
330˚
-5
-10
-15
-25
dB

focusrite.com Tell the world
Accessories and Spare Parts
Part Part Number
Metal Wave Washer *TBAMMxTBAMM* - DM14v FAST002094
Flat Metal Washer *TBAMMxTBAMM* - DM14v FAST002095
XLR Dress Ring - DM14v MISC002187
Pop Shield - DM14v MISC002188
Capsule Cage - DM14v MISC002189
XLR Connector Assembly - DM14v MISC002190
Mic Capsule Assembly Complete - DM14v MISC002191
Mic Support Bracket - DM14v MISC002194
Thumb Screw - DM14v MISC002195
Plastic Wave Washer *TBAMMxTBAMM* - DM14v MISC002198
To get spares for your Vocaster DM14v please either contact our Spares team or speak to
your local distributor:
Contact our Spares Team: support.focusrite.com
Contact your local distributor: stockists.focusrite.com
4