Foldcraft Plymold Z000000385 User manual

KDWallStyleAdjustable

Released11/30/16
Z000000385

WallFrameAdjustable
Assembly
Step2:FrameAssembly
a.Using3/8”‐16x33/4”hexheadcapscrew,3/8‐16lock
nutand3/8”washers,assembletheseatsupportlegto
themainsupportframe.
Note:StartwiththeCenterholesandifneededcan
openorclosetheboothopeningifneeded.






b.Repeatstepawiththesecondseatsupportleg.







c.Aachthecanlevertothemainsupportframeusing
1/4‐20x5/8”machinescrewsonthe
boom.Usethe1/4‐20x3/4”hexheadcapscrews
witha1/4‐20kepnutonthetop.



Step1:GlideAssembly‐AdjustableWallStyleFrame
a.Assembleathread‐inglideintotheinsert
ineachofthefour(4)legs.
(A)
(A)

WallFrameAdjustable
Step3:FastenGlidestotheFloor
a.Rotateglidessothatthemounngholeispoinngtowardsthecenterof
thebooth.
b.Withapencil,marktheholelocaononthefloorusingtheholesinthe
glide.
c.Turntheglideaway90degreesfromitscurrentposiontoexposethe
markonthefloor.
d.Usingahammerdrillanda1/4”masonrybit,drilla11/4”deepholeon
thepencilmark.
e.Placeaplascanchorintheholeandthenrotateglidebacksoitshole
linesupwiththeplascanchorinthefloor.