Foldcraft ADA User manual

ADAWallFrameAdjustable
Released11/09/2016
Z000000386

ADAWallFrameAdjustable
Assembly
(A)
(A)
(A)
(A)
(A)
Step2:FrameAssembly
a.Using3/8”‐16x33/4”hexheadcapscrew,
3/8‐16LockNutand3/8”washers,assem‐
bletheseatsupportlegtothemainsup‐
portframe.
Note:Useoutsideholes,noadjustment.






b.Aachsupportlegusing3/8‐16x3‐1/2”
capscrewbuonheadand3/4‐16lock
nuts.
Note:Placebuonheadoninsideofleg.




c.Aachtableangletomainsupportusing
1/4‐20x2.0”hexheadscrewsand1/4‐20kep
nut.Aachcanlevertomainsupportusing1/4‐
20x5/8”machinescrewsontheboomand1/4
‐20x3/4”hexheadcapscrewswitha1/4‐20
kepnutonthetop.

Step1:GlideAssembly‐ADAWallStyleFrame
a.Assembleathread‐inglideintotheinsert
ineachofthefour(6)legs.


ADAWallFrameAdjustable
Step3:FastenGlidestotheFloor
a.Rotateglidessothatthemounngholeispoinngtowardsthecenterof
thebooth.
b.Withapencil,marktheholelocaononthefloorusingtheholesinthe
glide.
c.Turntheglideaway90degreesfromitscurrentposiontoexposethe
markonthefloor.
d.Usingahammerdrillanda1/4”masonrybit,drilla11/4”deepholeon
thepencilmark.
e.Placeaplascanchorintheholeandthenrotateglidebacksoitshole
linesupwiththeplascanchorinthefloor.