for Living 088-1648-6 User manual

Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings
required.
Keep children away during assembly. This item contains small parts that can be swallowed by children.
Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
SERVICE CENTRE TOLL-FREE
TEL:[phone]
FAX:[phone]
8
1
8
8
Sutton Collection Dining Table
088-1648-6 (TCS64LC)
ASSEMBLY INSTRUCTIONS
ATTENTION:THIS PRODUCT IS NOT FOR COMMERCIAL
USE INTENDED FOR RESIDENTIAL USE ONLY.
!
FIGURE 1
1
4
14 7
PARTS LIST
PART
NO. MATERIAL CODE PART QTY
1
2
3
4
5
6
17C01A0706002Y4
13C??1B29008001
17FA05040301-Y4
18000337002
17KAA0201----Y4
WASHER d6.5*D13*1.0
BOLT CAP M6
HEX KEY WRENCH 6 MM
TCS64LC-CS04-1
TCS64LC-CS05-1
TABLE TOP
LEG
TILE
BOLT M6*16
22
4
5
6
4
5
6
2
1
1
2
Note:
The tiles can be easily broken, be careful when you
remove them. Do not throw the residual tiles away.
Retain them for future use.
Step 1:
Place the table top (1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Fasten the legs (2) to the underside of the table top (1)
rim by using bolts (4) and washers (5). Make sure that
all of the bolts have been tightened completely and
cover them with bolt caps (6).
!
!
!
!
!
!
2

FIGURE 2 FULL ASSEMBLY
Imported by Trileaf Distribution Trifeuil, Toronto, Canada M4S 2B8
If you need parts,
whether they are missing or damaged,
call Toll Free
TEL: [phone]
FAX: [phone]
Call us between 9:00 AM and 4:30 PM
Eastern Time, Monday through Friday.
PLEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING ASSEMBLY
PLEASE SEPARATE AND IDENTIFY ALL PARTS, MAKING SURE THAT YOU
HAVE ALL OF THE PARTS LISTED.
SHOULD YOU NOT LOCATE ALL OF THE ABOVE PARTS, PLEASE INSPECT
ALL PACKING MATERIAL FOR ANY SMALL PARTS THAT MAY HAVE
BECOME SEPARATED DURING SHIPMENT.
SHOULD YOU EXPERIENCE ANY DIFFICULTY DURING ASSEMBLY, OR IF
ANY PART IS MISSING OR DAMAGED, PLEASE CALL THE HELPLINE AT
1-877-539-7436.
PLEASE PROVIDE THE FOLLOWING INFORMATION:
1- MODEL NUMBER OF THE PRODUCT.
2- PART NUMBER AND MATERIAL CODE OF THE PART FROM THE PARTS LIST
SHOWN ON ASSEMBLY INSTRUCTIONS.
MOST PROBLEMS CAN BE SOLVED WITHOUT RETURNING THIS
PRODUCT TO THE RETAILER.
Note:
If the EVA foams on the table top are missing, replace
them with the EVA foams supplied in the hardware kit.
See Illustration A.
Step 2:
Turn the table to its upright position. Then, carefully
put the tiles (3) onto the table top (1).
1
A
3
Step 3:
See Full Assembly.
Note:
To use an umbrella with this table, remove the plastic
centre plug and put the umbrella pole through the table
top.
Cleaning and Maintenance
• Wash frame parts with mild soap and water, rinse thoroughly, and dry completely. Do not use bleach, acid, or
other solvents on the frame parts.
• Inspect and tighten all bolts and fasteners on a regular basis to ensure the proper performance and safety of
your table.
• When moving the table, remove the umbrella and lift. Do not drag this table.
• We recommend the use of furniture covers when not in use.
• In order to prolong the life and beauty of your table, we recommend that it be stored in a dry and protected
area during off-season periods.
• The umbrella should be lowered and/or removed in windy conditions.
Made in China