STORM RIDER / SHARK RIDER
CAR AND RIDER ASSEMBLY
STUNT INSTRUCTIONS
• Load batteries according to proper polarity indication
• Exhausted batteries should be removed from the toy
• The supply terminals shoud not be short-circuited
• Do not mix new and old batteries
• Take out batteries when not in use
• Do not over charge the battery
• Keep battery in a cool place - do not leave in direct
sunlight or exposed to heat
BATTERY CAUTION
Place your Rider's feet
into the car as shown
Please Refer To The Actual Product Size Ratio
Attach your Rider to
the car as shown
FORWARD
BACKWARD
SWITCH
Press and hold to turn
the transmitter on/off
Press and hold the left or right key, the car will
rotate 360° to the left or right on the spot
Press This Button To Transform To A New Position!
Insert 2 new AA batteries into the
back of the remote controller
(not included) be sure to check
their polarity.
Charging your rider:
1. Connect the battery to the USB cable
and plug it into a USB port.
2. The USB light will turn red while charging
3. The USB light will turn off when the
battery is charged
4. Charging time is approximately
150 minutes and play time is
approximately 12 minutes
Sound On/Off Lights On/Off
The rider will pause when changing positions,
press forward to complete the change.
Open the battery compartment at
the bottom of the car and plug the
3.7V lithium battery in. Close the
compartment before playing.
To drive in circles,
push the left and
right throttle
sticks at the
same time in the
directions shown
to the left.
AB
AB
