FORENO BLACK EDITION SBK041 User manual

FORENO TAPWARE (NZ) LTD | Freephone: 0508 FORENO | [e-mail] | 5 Hewlett Street, Port Whangarei 0110 | FORENO.CO.NZ
BLACK EDITION
Double Head Slide Shower (Square)
Matte Black SBK041
Congratulations on your purchase of this high quality product from Foreno Tapware.
Please read the following before installation and retain (along with your receipt) for future reference.
TECHNICAL SPECIFICATIONS
Suitable for Mains Pressure only
Minimum Pressure = 150kPa
Maximum operating Pressure = 500kPa* (As per NZ Building Code AS/NZ 3500.1)
Maximum operating Temperature = 65 deg. Celsius
For domestic use only.
CONFIGURATION
Mains Pressure systems Install as supplied.
Unequal Low Systems Not suitable.
Equal Low systems Not suitable.
INSTALLATION
*FOR PRESSURES EXCEEDING 500kPa INSTALL A PRESSURE REDUCING VALVE. THOROUGHLY FLUSH ALL
PIPES TO ELIMINATE ANY REMAINING DIRT AND RESIDUE, AND INSTALL INLINE FILTERS. FAILURE TO DO SO
MAY VOID THE WARRANTY.
CAUTION: IF USING YOUR OWN SCREWS TO INSTALL THE WALL BRACKETS, DO NOT USE COUNTER SUNK TYPE
SCREWS, AS THIS WILL VOID THE WARRANTY.
• Refer installation diagram, overleaf. This shower has a WELs certified flow regulator fitted between the shower
hose and the rail connection (see diagram 5). If you want a greater flow, remove this disc but note that this will
not give a WELS 3-star water rating.
TAPWARE MADE FOR NEW ZEALAND since 1969

=
PROUD PARTNER AND SUPPORTER OF MASTER PLUMBERS, GASFITTERS AND DRAINLAYERS
FORENO TAPWARE (NZ) LTD | Freephone: 0508 FORENO | [e-mail] | 5 Hewlett Street, Port Whangarei 0110 | FORENO.CO.NZ
ATTACH PROOF OF PURCHASE HERE
WARRANTY
PLEASE CALL US BEFORE REMOVING TAPWARE OR UNDERTAKING ANY REPAIR WORK.
Please refer to our website for warranty information: www.foreno.co.nz/warranty
In the unlikely event that this product fails during its warranty period, phone our Customer Service team
immediately on 0508 FORENO (0508 367 366) – as unauthorised removal of the product may void the warranty.
CARE AND MAINTENANCE
SHOULD NOT BE CLEANED WITH ACIDIC, CAUSTIC/ALKALINE, ABRASIVE OR CITRIC CLEANERS.
A so, damp cloth is recommended for cleaning (Not a Micro fibre cloth). Mild soap solutions can also be used on
occasion.
596mm 2
4
21 3
5
Shower wall outlet hole
24mm diameter
8mm diameter hole
Apply teflon tape
Screw threaded
adapter to wall
outlet then
tighten firmly
with allen key
Position Shower Rail over wall inlet and wall adapter and
gently push into place, then fasten the rail by tightening the
top and bottom grub screws.
OVERHEAD ROSE
HANDPIECE
Rubber washer
6. Turn on water supply. Check for leaks.
Flow restrictor
Push plastic plug into drilled hole.
Position mounting adapter over the hole
and screw firmly into place.
8L/min Flow Regulator
Black O-ring
Water Flow
**Ensure the flow regulator is fitted
with the O-ring facing away from the
hose (as shown), between Shower
connection and Hose. This will comply
with the WELS rating.
Do NOT fit between handpiece and
hose as this can overpressurise the
hose and cause premature failure of
the shower hose.