FORENO C2-2 User manual

9421027 592964
FORENO TAPWARE (NZ) LTD | Freephone: 0508 FORENO | [e-mail] | 5 Hewlett Street, Port Whangarei 0110 | FORENO.CO.NZ
FORENO Double Head Shower (Square)
Chrome C2-2
Congratulations on your purchase of this high quality product from Foreno Tapware.
Please read the following before installation and retain (along with your receipt) for future reference.
TECHNICAL SPECIFICATIONS
Suitable for Mains Pressure only
Minimum Pressure = 150kPa
Maximum operating Pressure = 500kPa
Maximum operating Temperature = 65 deg. Celsius
For domestic use only.
CONFIGURATION
Mains Pressure systems Install as supplied.
Unequal Low Systems Not suitable.
Equal Low systems Not suitable.
INSTALLATION
For pressures exceeding 500kPa install a pressure reducing valve. Failure to do so may void the warranty.
CAUTION: IF USING YOUR OWN SCREWS TO INSTALL THE WALL BRACKETS, DO NOT USE COUNTER SUNK TYPE
SCREWS, AS THIS WILL VOID THE WARRANTY.
• WELS 3 Star Restrictor - Note that the FORENO C2-2 has a WELS certified disc fitted (see diagram 5 & 6 below).
If you want greater water flow remove these discs, but note that this will not give a WELS 3 Star water rating
anymore.
• Refer diagram, overleaf.

=
PROUD PARTNER AND SUPPORTER OF MASTER PLUMBERS, GASFITTERS AND DRAINLAYERS
FORENO TAPWARE (NZ) LTD | Freephone: 0508 FORENO | [e-mail] | 5 Hewlett Street, Port Whangarei 0110 | FORENO.CO.NZ
ATTACH PROOF OF PURCHASE HERE
WARRANTY
Please refer to our website for warranty information: www.foreno.co.nz/warranty
In the unlikely event that this product fails during its warranty period, phone our Customer Service team
immediately on 0508 FORENO (0508 367 366) – as unauthorised removal of the product may void the warranty.
CARE AND MAINTENANCE
NOT TO BE CLEANED WITH ASTRINGENT, ABRASIVE OR CITRIC CLEANERS.
A so, damp cloth is recommended for cleaning. Mild soap solutions can also be used on occasion.
Rubber
Washer
Flow
Restrictor
Diverter Operation
450-500mm
recommended
Shower Wall Outlet
hole 25mm
diameter
7mm diameter hole
Screw threaded adaptor to wall outlet.
Push plastic plug into drilled
hole. Locate lower mounting
screw in place.
SHOWER
HAND SHOWER
1 2
restrictor as shown into Shower
Rose.
Screw Shower Rose to arm.
restrictor as shown into Shower
Hose.
Screw Shower Hose to Hand
Shower
and Shower Rail
3
6
Test and check
for leaks
x2
x2
Rubber
Washer
Flow
Restrictor
Gently push Shower Arm and
Main Tube onto the Inlet Body
spigots. Tighten 2x grub
screws above and 2x grub
Adjust Lower Body to correct
position and tighten
grub screw.
Position Shower Rail over Wall
Inlet Adaptor and lower Wall
Adaptor and gently push in
place.
Fasten Shower rail by tightening
top and bottom grub screws.
x2
x2
Slider
Main Tube
Lower Body
Slide Main Tube through the
Lower Body. Fit Slider onto
Main Tube and slide into place.
Shower Arm
Inlet Body
Main Tube
4 5