FORENO FSM4 User manual

9421009 511310
FORENO TAPWARE (NZ) LTD | Freephone: 0508 FORENO | [e-mail] | 5 Hewlett Street, Port Whangarei 0110 | FORENO.CO.NZ
Shower Mixer
FSM4
Congratulations on your purchase of this high quality product from Foreno Tapware.
Please read the following before installation and retain (along with your receipt) for future reference.
TECHNICAL SPECIFICATIONS
Suitable for All Pressures
Minimum Pressure = 35kPa
Maximum operating Pressure = 500kPa
Maximum operating Temperature = 65 deg. Celsius
For domestic use only. Only slide showers that are equipped with a large internal bore hose and open flow one
function handset will work eectively with this shower mixer. We recommend the FSL8 MonoJet slide shower for
optimum performance.
CONFIGURATION
Mains Pressure systems Remove the insert from the cold side marked with a ‘C’.
Unequal Low Systems Install as supplied.
Equal Low systems Remove the valve inserts from both inlets, prior to installation.
INSTALLATION
For pressures exceeding 500kPa install a pressure reducing valve. Failure to do so may void the warranty.
• See diagram, overleaf.
• Where back flow prevention is required, install our Back Flow Prevention Valve (part FORPT79) at the supply
elbow hose connection of the handpiece.
• Screw the shower arm to the wall connection and tighten.
• Shower mixers must be water tested with the outlet open, to prevent damage to cartridge seals due to back
pressure.
• Turn on water supply. Check for leaks.
• Any water seepage ex- the cartridge cavity opening can be stopped by retightening the large brass retaining nut.

PROUD PARTNER AND SUPPORTER OF MASTER PLUMBERS, GASFITTERS AND DRAINLAYERS
FORENO TAPWARE (NZ) LTD | Freephone: 0508 FORENO | [e-mail] | 5 Hewlett Street, Port Whangarei 0110 | FORENO.CO.NZ
ATTACH PROOF OF PURCHASE HERE
Plumbers Note: Do not pressure test this mixer under static pressure.
WARRANTY
Please refer to our website for warranty information: www.foreno.co.nz/warranty
In the unlikely event that this product fails during its warranty period, phone our Customer Service team
immediately on 0508 FORENO (0508 367 366) – as unauthorised removal of the product may void the warranty.
CARE AND MAINTENANCE
Chrome-plated finishes should not be cleaned with astringent, abrasive or citric cleaners.
A so, damp cloth is recommended for cleaning. Mild soap solutions can also be used on occasion.
450mm minimum
straight distance
HOT supply only
COLDsupply only
**tosuitfaceplate
Min 45mm
Max 60mm
150mm Faceplate
**Min = Ø80mm
**Max = Ø100mm
115mm Faceplate
Seal with silicon
if necessary