FOREVER Call Me 2 User manual

MANUAL
Smartwatch KW-60
(long version)

1
2
3

4
5
6
7
8

4
Thank you for buying Setty brand product. Before use, read
EN this instruction manual and keep it for future reference. Do not
open the device on your own –any repairs should be carried
out by a serviceman. Only use original parts and accessories
supplied by the manufacturer. The device must not be exposed
to direct fire or other heat sources. We hope that Setty will meet
your expectations.
Introduction
Before using the kids watch, carefully read the instruction ma -
nual to ensure correct operation. Kids watch is a small telecom-
munication device, used to locate its position and send data.
Operation of the device is based on GSM/GPRS mobile network.
Specification
Display: 1.44’’ 128x128 px
Touch screen: yes
Standby time: do 2-3 days
Charging time: 2-3 hours
Strap length: 230 mm
Battery: 400mAh
Camera: yes
Microphone and speaker: built-in
Sim card: micro SIM (with no PIN lock)
Compatibility: Android ≥5.0 , iOS ≥10.0
Important!
The device requires installation of a micro SIM card with active
service, allowing to make and receive calls, with no PIN lock. It is
recommended to deactivate voicemail. When sending informa-
tion regarding location, the watch will require access to mobile
Internet, therefore, you should buy at least 1 GB package. Use of
the watch may be associated with fees for using the network and
c a ll s , i n a cc o r dan ce w i t h t h e op er a t o r ’ s t a r i ff.

5
Device description
1. Speaker
2. Micro USB connector
3. Microphone
4. Camera
5. Answear the call / Turning on the flashlight (after pressing
twice)
6. Flashlight
7. On/Off/SOS buton/Return to mine screen
8. Function touch button - return to the start screen
The set includes
- smartwatch
- charging cable
- user manual
Charging
It is recommended to use a charger of output parameters of
5V ⎓1A. Charger is not included in the set. Full charging time
of the watch is approximately 2 hours. Open the plug protec -
ting the micro USB port, then connect the included micro USB
cable and connect the device to a power source.
1. Installing the SIM card
Always make sure your watch is turned off before inserting or
removing the SIM card. Never insert or remove the SIM card
when the watch is turned on. Open the back cover of the watch
by gently prying it at the top and sides until the latches are unfa-
stened. Then remove the battery, taking care not to damage the
battery cables. Remember its position. Open the micro sim card
cover by sliding it slightly to the right, and then insert the SIM
card into the slot in such a way that the sim card chip is facing
upwards to the watch screen. Then close the lock by sliding to
the left. Place the batteri in the watch in it original position, then
close the back cover by pressing the latches.
EN

6
2. First run
EN After installing the SIM card in the watch and charging the devi-
ce, you can start it by pressing and holding the on button.
- After starting, the watch connects to the mobile network.
3. Device operation
We operate the device via a touch screen. By sliding your finger
on the screen, you can switch between individual functions and
you select a given function by pressing the screen.
1. Device home screen showing the current date and time as well as
battery level. On this screen, we also see the icon for connecting
to the mobile network and the icon for the amount of contractual
awards received.
2. Enables you to make a phone call by manually entering the number.
3. The phone book gives you access to 10 contacts defined using the
application.
4. Allows you to take a photo that will be saved in the album.
5. Access to the last photo taken. Possibility to preview, send or delete
it. Each subsequent photo taken overwrites the previous one.
6. A simple math game with three levels.
7. It allows you to send voice messages and receive text and voice
messages.
8. It allows you to start the flashlight built into the watch.
9. It allows you to read the registration QR code for the device and the
application QR code.
4. Use of application
Download the „Forever Care” app for iOS or „Forever KidsCare”
for Android.

7
EN
Account and watch registration:
In the registration window, enter your email address, password and
the area of use of the watch. Then enter or scan the watch code (REG
CODE) found on the bottom of the box and on the watch.
Functions
- Chat: Send a text or voice message to the watch by typing it on
the keyboard or recording it using the phone’s microphone.
You can also listen to the voicemails sent from the watch here.
- Route: select the date and time slot to display the traveled
route.
- Map: Select the map icon to view the current location of the
watch.
- Safety zone: designate a safety zone, when the watch will fo-
und outside the selected zone, you will receive a notification
from the app.

8
- Reward: Select the number of rewards you want to send to
EN your child. After approval, the information about the award
will be sent to the watch.
- Alarm clock: alarm clock settings. Set the desired time and
frequency of repeat.
- Find Watch: Select a feature to find your device if it’s near
you. The watch will ring to inform you of its location.
- Notifications: This is where you get and preview any notifica-
tions and alarms you receive from the watch.
- Remote camera: take a photo using the watch camera and
receive it on your phone. The captured image appears after
a certain waiting time, depending on the signal strength of
the cellular network.
- My profile:
• Personal data: Your account settings
• Device list: Add, edit or remove a connected devices
• Change Password: Change the password for your account.
Settings
• SOS numbers: when the watch user presses and holds the
SOS button, the watch makes an automatic emergency call to
three contacts defined on list.
• Voice monitoring: enter the phone number to be called
from the watch in order to listen to its surroundings. Pick up
the call and check what’s happening nearby. The user of the
watch has no notification that such a call has been made.
• Do not disturb: Select the time during the day when the user
of the watch will not receive phone calls.
• Location mode: select normal mode - refreshing the watch’s
location once every ten minutes, power saving - once every
hour, tracking - once every minute.
• SMS notifications: enter the number to which you want to
receive SMS notifications about events such as: low battery
level in the watch, triggering the SOS alarm using the watch
button.
• Phone book: Define up to ten contacts that the watch user
will have in the phone book.

9
• Time zone: set your time zone than the device shows the cor-

10
rect date and time on.
• Language: Choose language for your device from the available.
• Settings switch: Enable or disable the watch function.
• LBS Location: Enable or disable location using network ope-
rators antennas.
• Turn off watch remotely: watch will be turned off.
FAQ
The application does not receive commands and shows in-
formation that the watch is disconnected from the network.
–Check whether GMS signal is correct–whether the range columns
are available / visible on the display. - - - If they are crossed out,
please turn off your watch.
Check if the SIM card is properly installed in the watch, if it supports
2G internet and if there is an internet data package available.
Turn on the device. If the range columns are still crossed out, go to
the next point.
- Check if there are data transfer arrows, if not, set APN (Access Point
Name - specific packet network, e.g. internet):
Please send a text messag e to the number of the watch with the con -
tent:
pw,123456,apn,YYYYY,,,XXXXX#
* the Xcharacter stands for digits of MNC and MCC codes assigned to
a specific operator, e.g .:
26003 –ORANGE
26001 –PLUS
26006 –PLAY
26002 –T-MOBILE
the remaining digits of the codes are available at manual/forever.eu or
www.mcc-mnc.com/
* Instead of the Y characters, enter the operator's individual APN
name.
After sending the message, wait several minutes for KidsWatch to
download the settings from the network . Data transfer arrows will
appear.
EN

11
- Please send a text message to the number of the watch with the
content: pw,123456,ts#, in response, the watch will send us the
parameters of the watch. An example:
ver:G36WS_YDE_V1.1_2019.12.19_09.45.40;
ID: 1234567890;
imei:123456789012345;
ip_url:52.28.132.157;
port:8001;
upload:600S;
bat level:96;
language:1;
zone:10.00;
ec:0;
NET:OK(73);
Check the data received in the SMS with the watch number.
- If the number ID/IMEI/REG CODE is different from the badge on the
watch or the bottom of the package, set a new IMEI number.
Please send a text message to the number of the watch with the con-
tent: pw,123456,imei,xxxxxxxxxxxxxxx# where X are the numbers
from the badge - the watch, after receiving the SMS with the code,
sends back in the SMS response with the correct IMEI number, for
example: pw,123456,imei,359614514986574#
Could not call watch. The signal is busy or the subscriber
does not answer
Reason: The watch does not recognize the incoming number or
the app is set to do „not disturb”.
Solution:
- Check if the number you are calling from is hidden number.
- Check if there are contact numbers in the application.
Attention
when writing text messages, pay attention to punctuation
marks and spaces. This is very important because if the cha -
racters are not used correctly, the commands will be misin -
terpreted by the watch and will remain unanswered.

12
The watch only receives calls from numbers previously set in the
contacts of the application.
The watch does not show the current time and date
Reason: The watch did not connect to the application server to
update the time.
Solution:
- If the watch shows several hours back, check and select the
correct time zone via the app.
Rules for safe use
• Read and keep this manual.
• There are no user-serviceable parts inside. All repairs should be
performed by a service technician.
• Protect the device from contact with water and moisture to avoid
damage to electronic parts. Avoid very high temperatures; they
can shorten the life of electronic device components or melt pla-
stic parts.
• Note: Use only original parts / accessories provided by the ma-
nufacturer.
• Follow the instructions in the manual. The product is not a toy.
The maximum radiated radio frequency power in the
frequency range
Frequency range:
GSM 900/1800 MHz
Transmit power
33,51/30,44dBm EIRP

13
DeclarationofconformitywiththedirectivesoftheEutropeanUnion
TelForceOne Sp. z o.o. hereby declares that the Kids Watch KW-60 Call Me! 2 is in
compliance with Directive 2014/53 / EU. The full text of the EU declaration of
conformity is available at the following internet address:
www.manual.forever.eu/KW60
Manufacturer’s data:
ul. Krakowska 119
50-428 Wrocław, Poland
Made in China

14
CORRECT DISPOSAL OF USED EQUIPMENT
The device is marked with a crossed-out garbage bin,
in accordance withthe European Directive 2012/19/
EU on used electrical and electronicEquipment (Waste
Electrical and Electronic equipment - WEEE).Products
marked with this symbol should not be disposed of or dumped-
with other household waste after a period of use. The user is
obliged toget rid of used electrical and electronic equipment by
delivering it todesignated recycling point in which dangerous
waste are being recycled. Collectingthis type of waste in desi-
gnated locations, and the actual process of their recoverycon-
tribute to the protection of natural resources. Proper disposal
of used electricaland electronic equipment is beneficial to hu-
man health and environment. To obtaininformation on where
and how to dispose of used electrical and electronicequipment
in an environmentally friendly manner user should contact their
localgovernment office, the waste collection point, or point of
sale, where the equipmentwas purchased.
CORRECT DISPOSAL OF USED BATTERY
According to the EU directive 2006/66/EC with
changes contained inEU directive 2013/56/UE on
the disposal of batteries, this product ismarked
with crossed-out garbage bin symbol. The symbol
indicates thatthe batteries used in this product should not be
disposed with regularhousehold waste, but treated according
to the legal directives and local regulations.It is not allowed to
dispose of accumulators with unsorted municipal waste. Users
ofaccumulators must use the available collection points of the-
se items, which allowsthem to return, recycle and dispose of the
accumulators. Within the EU, thecollection and recycling of bat-
teries and accumulators is a subject to separateprocedures. To
learn more about existing procedures of recycling of accumula-
torsplease contact your local office or an institution for waste
disposal or landfill.
EN

15
www.forever.eu
2011/65/ UE