Fortin EVO-ONE User manual

REVO GUIDE # 88751 - REV.: 20190715
Parts required (not included):
1x FLASH-LINK UPDATER
1x Microsoft Windows Computer with Internet connection
1Plug in the FLASH-LINK UPDATER into the computer’s USB port with the
provided USB cable.
2Run Flash Link Manager Software.
3Plug in the EVO-ONE into the FLASH-LINK UPDATER with provided
DATALINK cable.

PAGE 2 / 4 REVO
4
Once the ashing is done,
CLICK on CONFIGURATION
then UNIT OPTIONS.
5
SELECT Fortin2,
CLICK SAVE,
wait for the window to disappear
6Disconnect the EVO-ONE.

PAGE 3 / 4 REVO
7
DCBHIJ
Red White Blue Blue Black
CONNECT the REVO in the Blue 4pin connector with clip of the
EVO-ONE using a 4pin connector with clip.
Do not force in an incompatible connector.
8
STEP 1 STEP 2 STEP 3 STEP 4 STEP 5 STEP 6
WITH IGNITION SWITCH
Turn the Igni-
t i o n O F F.
Turn the
Ignition ON. x4
Press and
release the
brake pedal
four times.
Turn the
Ignition
ON.
WITH VALET SWITCH
Press and hold
Valet switch
until the side
red light ash
on EVO-ONE
then release. x5
Press and release
the valet switch ve
time.
The parking lights
will ash and the
horn/siren will
chirp each time to
conrm.
x1
Press and
release the
brake pedal
once.
On each Transmitter press
and release the LOCK
button
Turn the
Ignition OFF to
exit program-
ming.
To program the remotes on the EVO-ONE, Turn IGNITION ON. Press and hold
Valet switch until the side red light ash on EVO-ONE then release. Press
and release the Valet switch 5 times. Press and release the Brake pedal
once. Press lock one any remote. Turn IGNITION OFF.
OR
Turn the ignition ON, Turn the ignition OFF, Turn the ignition ON and press
4 times on the brake pedal. Press lock one any remote. Turn IGNITION OFF.
MODE 1 - LOCK
MODE 2 - UNLOCK
MODE 3 - TRUNK
MODE 4 - START
MODE 5 - AUX.1
MODE 6 - AUX.2
If you want to change EVO-ONE options, use the following button map-
ping.S

PAGE 4 / 4 REVO
WARNING
NOTICE The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product,
including either damage to the vehicle itself or to the remote-starter module. This module must be installed by a certied technician
including all of the supplied safety devices. Please note that this guide has been written for trained professional technicians, a certain
level of skills and knowledge is therefore assumed.
Neither the manufacturer or distributor of this module is responsible of damages of any kind indirectly or directly caused by this mo-
dule, except for the replacement of this module in case of manufacturing defects. This module must be install by qualied technician.
This instruction guide may change without notice.
To download the installation guide, user guide, or the latest quick installation guide, visit: www.fortin.ca
Technical support: TEL: [phone]
Copyright © 2019, FORTIN AUTO RADIO INC ALL RIGHTS RESERVED MADE IN CANADA REV.:20190517