www.foundmotor.com info@foundmotor.com
Connections:
1. Connect the red wire to the positive.
2. Connect the black wire to the negative.
3. Connect the blue wire to the controller of the electric door
lock.
4. Connect the green wire to the controller of the motor
power intensity control wire.
1. Start
Press the button to power on the manual control panel, and the blue
wire connected to it will deliver the same output voltage as the power source.
The maximum operating current of the blue wire can reach 200mA.
2. Battery Level Indication
The LED indicators will show full bars when the battery is fully
charged. The LED indicator will start blinking continuously at low
battery, which indicates a battery recharge asap.
3. Motor Power Intensity Control
Please refer to this section as the control and
indicating part of the motor power intensity. The default intensity at boot is LOW,
and the corresponding output voltage is 2V. The control signal of the motor
power intensity will shift at each press of the mode button . The
control indicator will change from LOW to MED after pressing the mode button
for the first time, when the corresponding output voltage is 3V. The control
indicator will change from MED to HIGH after pressing the mode button for the
second time, when the corresponding output voltage is 4V. When pressing the
mode button for the third time, the motor power indicator will be set back to
LOW, and the output power will be reset to 2V.
