
– 7 –
FHM 302 2C M EN
Risk of fire!
Unattended cooking on a hob with fat or oil
can be dangerous and may result in fire. Hot
oil ignites readily.
Prepare food with plenty of fat (such as
chips) only under constant supervision.
Never try to extinguish fire with water.
In the case of a fire, switch off the
appliance and cover flame e.g. with a lid or
with a fire blanket.
To avoid damaging the appliance
In the case of thermal failure, switch the
solid plate off and allow to cool down
completely.
Do not put any dishes on it. Do not cool
with cold water under any circumstances.
Do not climb onto the appliance.
To avoid damaging the silicon grouting, do
not put hot cookware on the frame.
Do not cut or prepare food on the surface
or drop hard objects onto it. Do not drag
cookware across the surface.
Make sure than no sugary foods or juices
end up on the hot cooking zones. This can
damage the surface. If sugary foods or juices
do end up on the hot cooking zones, remove
these immediately with a glass ceramic hob
scraper (while the hob is still hot).
Do not leave the appliance unattended
during operation.
Pots with pure copper or aluminium leave
behind traces that can be difficult to clean. If
the traces are not removed immediately after
cooking with a suitable cleaning agent, they
can be permanently burned on and therefore
permanently ruin the visual appearance of
the appliance.
Do not use pots with pure copper or
aluminium bases for cooking.
Sliding pots and cookware across the glass
ceramic causes scratches.
Avoid scratches by lifting pots and
cookware when putting them into place.
The hob is an item for daily use: signs of
usage such as scratches or visible material
abrasion from pots or cookware are normal.
Intensive use leads to more distinctive
signs of usage. In such cases, the appliance
continues to function perfectly and a
complaint is not justified. Safety is always
guaranteed.
Maintenance and cleaning
Do not use harsh abrasive cleaners or
sharp metal scrapers to clean the hob,
since they can scratch the surface, which
may result in shattering of the glass.
Do not use steam cleaners or direct jets
of water.
Risk of electric shock due to entering
liquid!
The device contains electrical components.
Make sure that no liquid enters the interior
of the device.
Do not use pressurised steam to clean
the device.
Repair
The appliance is manufactured in compliance
with the relevant effective safety standards.
Do not allow anyone except qualified
personnel to install or repair the appliance.
Contact a service centre authorised by the
manufacturer or qualified personnel in the
following cases:
– Immediately after unpacking, in the event of
doubts regarding the integrity of the device
– During installation (according to the
manufacturer‘s instructions)
– Doubts regarding the correct operation of
the device
– Malfunction or poor operation
– Replacing the power socket if incompatible
with the power plug of the device
– If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
Use original spare parts only.
Taking out of service
If the appliance is no longer to be used, call
the service centre or qualified personnel to
disconnect it from the power supply.