
7
1. SAFETY
INFORMATION
For your safety and correct
operation of the appliance,
read this manual carefully
before installation and use.
Always keep these instructions
with the appliance even if you
move or sell it. Users must fully
know the operation and safety
features of the appliance.
The wire connection has to
be done by specialized
technician.
•The manufacturer will not be
held liable for any damages
resulting from incorrect or
improper installation.
•The minimum safety distance
between the cooker top and
the extractor hood is 650 mm
(some models can be installed
at a lower height, please refer
to the paragraphs on working
dimensions and installation).
•If theinstructions forinstallation
of the gas hob specify a
greater distance, this must be
respected.
•Check that the mains voltage
corresponds to that indicated
on the rating plate xed to the
inside of the hood.
•Means for disconnection must
be incorporated in the xed
wiring in accordance with the
wiring rules.
•For Class I appliances, check
that thedomestic power supply
guaranteesadequate earthing.
•Connect the extractor to the
exhaust ue through a pipe of
minimum diameter 120 mm.
The route of the ue must be
as short as possible.
•Regulations concerning the
discharge of air have to be
fullled.
•Do not connect the extractor
hood to exhaustducts carrying
combustion fumes (boilers,
replaces, etc.).
•If the extractor is used in
conjunction with non-electrical
appliances (e.g. gas burning
appliances), a sufcient degree
of aerationmust beguaranteed
in the room in order to prevent
the backow of exhaust gas.
When the cooker hood is used
in conjunction with appliances
supplied withenergy otherthan
electric, the negative pressure
in the room must not exceed
0,04 mbar to prevent fumes
being drawnback into theroom
by the cooker hood.
•The air mustnot be discharged
into a ue that is used for
exhausting fumes from
appliances burning gas or
other fuels.
•If the supply cord is damaged,
it must be replaced from the
manufacturer or its service
agent.
•Connect the plug to a socket
complying with current
regulations, located in an