Note: The first user and the last user (as below A and F) can not pair with each other
-
8
-
Function Key Operation Prompts
“Power off”
...“Clear
pairing”
Step 1: Clear the
pairing history of
A,B,C,D,E, F
Step 2:Pair two
neighbor devices,
in the order of A
→B→C→D→E→
F
Press and hold the ON/Off key of A,B,C,D,E,F for 3
seconds, keep pressing for another 5 seconds when
you hear the prompt“power off”, until you see the red
light flashes twice quickly.
Refer to the pairing methods of two users to pair A and B,
and then turn off B. (Note: When you are turning off the
device, release your hand once you hear the prompt
“Power off” ，otherwise B will be disconnected with A.)
Step 3: Create
group chats
Exit group chat
Resume intercom
with the front or
back user
Incoming call
during group
intercom
Pair B with C，and turn off C when the pairing is finished
Pair C with D，and turn off D when the pairing is
finished
Pair D with E，and turn off E when the pairing is
finished
Pair E with F. (At this time, all the devices are power
on.)
Press D once to connect with E; Press C once to
connect with D; Press B once to connect with C; Press A
once to connect with B.(At this time, all the devices are
connected successfully and are ready for group
conversations.)
When you are in a group chat, you can click the WIFI key
(intercom key) to exit the chat，then the group will be
split int two with you as the breaking point.
1. If you are in the first or last position of the group, click
the WIFI key (intercom key) once to resume the
intercom;
2. If you are in other positions of the group, double click
the WIFI key (intercom key) to resume intercom with the
upstream user (i.e.: double click the intercom key of E to
connect with D), click the WIFI key (intercom key) once
to resume intercom with the downstream user (i.e.: Click
the intercom key of E once to connect with F).
When there is an incoming call during intercom among multiple users, you will be
forced to disconnect the intercom, and then the intercom units before and after you
will be split into two intercom groups. (The intercom units before you as one group
and the intercom units after you as another group. When you refuse or hang up the
call (within valid connection range), you will return to the previous intercom state.
“Intercom
connected”
“Power off”
“Intercom
connected”
“Intercom
connected”
“Intercom
disconnected”
“Intercom
connected”
“Intercom
connected”
