FreeWheel Folding Wheelchair Adaptor Manual

Folding Wheelchair Adaptor: Set-Up Instructions
STEP 1: Getting Started
A. Separate tubing
B. Slide HITCH on to one side of tubing. Slide tubing
back together.
C. Open Knobs and remove Tube Shims.
STEP 2: Securing Adaptor to Your
Wheelchair
A. Clip Tube Shims onto horizontal tubing. Do NOT
use Tube Shims if tubing 1-1/8” in diameter.
B. Slide center bar to width of wheelchair and close
clamps over wheelchair tubing.
C. Secure clamps by lifting knob into slot and
tightening.
D. Move hitch so it is perfectly centered between
tubes.
B
TM
A
A
D
C
B
C

STEP 3: Attaching FreeWheel
A. Start with the FreeWheel angle adjustment in
the middle of it’s range (see pg. 4 of Set-Up
Guide).
B. Raise front casters approximately 1/4”.
C. Clamp FreeWheel on to Hitch with FreeWheel
in Tail Dragger position.
STEP 4: Final Adjustments
A. Securely tighten all 4 of the screws.
(20 ft-lbs).
B. Sit in chair and rotate tire under the
FreeWheel frame.
C. If your toes hit the wheel, loosen clamps and
move Adaptor forward on the horizontal bars.
C
A
C
Please refer to the FreeWheel Set-up Guide to fine tune any adjustments.
For more information or questions, contact us at:
Email: [e-mail]
B
A
B
Hitch