FreeWheel RACK User manual

Wheelchair Attachment RACK
Installaon Guide
Parts Included
1. 6 O-Rings, 4 Zip-Ties, 2 Foam Strips, 2 Sockets, 2 Sliders/Locks, 2 Retaining Screws
2. 2 Ball Fittings, 2 Washers, 2 Buttonhead Screws
3. 1 Block, 2 Socket Head Cap Screws
Tools Needed
Phillips Screw Driver, 5/32” allen wrench, wheel bearing grease
When Using Your RACK
1. Do not overload your RACK. Manufacturer maximum weight specifications is 25 lbs.
2. To make it easy to insert the Ball Fitting into the Socket, it helps to lightly dab wheel bearing
grease on each Ball Fitting (can be found at any auto parts store).
3. If the width between your vertical tubes is over 13-3/4” please contact us for an additional
part.
1. Socket and Slider/Lock 3. Block Centered
2. Width Adjustment
TM
For additional information or questions please go to our website or email us at:
WWW.GOFREEWHEEL.COM or [email protected]
*** OVER ***

Boom of foam strip 11” from
oor withOUT FreeWheel on 3 - O-Rings
Retaining Screw
Slider/Lock
Zip-Ties and
Foam Backing
Buonhead Screw Ball Fing
Washer
STEP 1
STEP 2 STEP 3
Center Block at top of
FreeWheel
11”