Frigicoll MD-LonGW64/E User manual

OWNER'S MANUAL
MD-LonGW64/E / K01-LON
Thank you very much for purchasing our product. Before using it, please read this
manual carefully and keep it for future reference.

MD-LonGW64/E / K01-LON
MD-LonGW64/E / K01-LON
Lonworks BMS gateway: K01-Lon
The new LonWorks gateway K01-Lon has been compliance with Lonworks standard and can be connected
up to64 indoor units to the LonWorks network directly. It can connect multiple refrigeration systems and do
not need to connect KCC-64.For full V4 plus system can be connected KCC-64, and it must be connected
from outdoor unit’s XYE, the new and the old indoor units or V4 indoor units cannot be applied to this
function. K01-Lon helps other LonWorks devices gathering the information from the Kaysun central A/C, and
help setting the indoor units’ working mode.

Connect Central A/C system to LonWorks network.
The core control module applies flash memory. Easily download the
program on line.
K01-Lon gateway applies non-polar twisted pair lines, which makes
connecting to LonWorks network easily.
e able to bridge the indoor units to the MS.

General Function
Monitoring Controlling
ON/OFF status report Mode setting for single unit
Running mode status report Mode setting for all units
Fan speed status report Stop setting for single
Set temp. value report Emergency stop for single unit
Indoor temp. value repot Fan speed setting for single unit
Error status report Fan speed setting for all units
Online/offline status report Temp. setting for single unit
Quality of connection status report Temp. setting for all units

System configure
Indoor units can be connected to the K01-Lon gateway, and we can gather all the units’ information and
control the indoor unitsthroughK01-Lon . As a result, the indoor units need firstly connecting to the computer
to make a central monitoring system. The composition of the whole network is as follows:
This connection method is suitable for all of the air conditioners system.
Notes: If there are a few K01-Lon devices to compose a LonWorks network, the LonWorks terminals of the K01-Lon are able to
be connected in the hand-in-hand way. And can be connected up to 64 indoor units to the LonWorks network.

Connecting ports
LON- and LON+ port: The ports should be connected to the computer’s COM port, using the RS-232
communicative standard.
X Y E port:These ports use a removable connecting way to help user connect the LonWorks network
conveniently.
POWER: This port should be connected to the AC220V power adaptor.
External View
Dimensions: 31.9*25.1*6.1
Notes:There are three installation methods as the following figure. Don’t install the unit in any other orientation.