Front Runner TEGO WALL User manual

Axle dimension 1 m (39.37“)
Height approx. 2.20 m ( 86.61“)
Tego waLL ASSEMBLY MANUAL 2 m

1. Make sure the base part is even
with the edge of the stand.
2. Use a wooden block and a rubber
mallet to hammer the base part
into the stand.
3. Unscrew all feet by 3-4 cm (1.18“
- 1.57“). Do it prior to setting the
shelf up, as adjusting it back to
the required position is easier
this way.
Tego waLL ASSEMBLY MANUAL 2 m
Page 2/4

4. Erect the assembled elements and
set them up using the attached
back panels. Use the bubble level
to check the vertical and horizontal
position of the shelf, adjust using
the feet if required.
In case of shelf elements heavily loaded on one
side, it would be sensible to either fix them to the
wall to prevent from tipping over or to additionally
install the free-standing shelves on the base
parts. It shall be checked on site.
5. Install the base panels
6. Install the bottom shelves
towards the clicking position.
Tego waLL ASSEMBLY MANUAL 2 m
Page 3/4

7. According to this layout, hook in
the rear panels one after another
from the bottom to the top.
Remove the stabilising rear panels
accordingly while doing so.
We hope you will enjoy the new shelf.
Tego waLL ASSEMBLY MANUAL 2 m
Page 4/4