FrSky FAS100 ADV User manual

Thank you for purchasing FrSkyCurrent Sensor – FAS100 ADV. It is designed for FrSky Smart Port enabled system,
and can measure Current (A) and Battery Voltage (V) when connected between a Battery and ESC and it has two
temperature sensors. In order to fully enjoy the benefit of it, please read the instruction manual carefully and set up
the device as described below.
Introduction
FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Version
1.0
Instruction Manual for FrSky
Current Sensor — FAS100 ADV
Note: All instructions, warranties and other collateral documents are subject to change at the sole
discretion of FrSky Electronic Co., Ltd. For further information, please visit www.frsky-rc.com
and click the support tab for this product.
Specifications
• Dimension: 65*23*18mm (L*W*H)
• Weight: 30g
• Measurement range: 0~100A
• Current consumption: 16mA@5V
• Maximum safe current: 100A
• Peak current: 150A
• Maximum battery voltage: 14S
•
Compatible with FBUS/S.Port protocol
• Connector: XT90 Anti spark
Connect the output Port of the sensor to the receiver, select Smart Port on the receiver setup screen, the sensor will
automatically recognize.
Protocol switching
Overview
TEMS
Measured Range:
TEMS: -55℃~250℃ / -67℉~482℉
Deviation: ±5%
23 mm
65 mm
XT 90
XT 90-S
Bat
To other FrSky FBUS/S.Port
Enabled Sensor
RECEIVER
XT 90
XT 90-S
ESC
TEMS
To the FrSky receivers
FrSky Current Sensor – FAS100 ADV is compatible with FrSky Smart Port enabled receivers. For more details,
please refer to corresponding receiver instruction manual.
Set Up

FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Version
1.0
Instruction Manual for FrSky
Current Sensor — FAS100 ADV
The Battery and ESC should be connected to BAT port and ESC port correspondingly and make sure the polarity is
correct. FrSky is not responsible for any damage caused by wrong polarity connection.
LED Status
FBUS
NO
YES
LED Status
Flash slowly
Flash quickly
S.Port
YES
NO
Other FrSky S.Port
or FBUS enabled sensors include new Smart Port enabled Variometer Sensor, GPS Sensor,
RPM Sensor, Airspeed Sensor, and so on.
Warning: Install FrSky Current Sensor – FAS100 ADV on any appropriate surface of the airframe that
stays away from water, vibration, or fuel.
ID Set Up
Note: All sensors could daisy chain with each other through their Smart Port.
Each type of FrSky sensors has its unique physical ID. The default physical ID for this sensor is 02. The ID number
could be changed by Free Link (Windows/android/ios)