FrSky FLVS ADV User manual

Instruction Manual for FLVS ADV Li-Po Voltage Sensor
FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
Note: All instructions, warranties and other collateral documents are subject to change at the sole
discretion of FrSky Electronic Co., Ltd. For further information, please visit www.frsky-rc.com and
click the support tab for this product.
Thank you for purchasing FrSky Li-Po Voltage Sensor. It is designed for FrSky Smart Port enabled system, and can
measure cell Voltages as connected. There're two versions, one with a screen and the other without it. In order to
fully enjoy the benefit of it, please read the instruction manual carefully and set up the device as described below.
Introduction
Specifications
• Dimension (L*W*H) :
- 52*23.5*9.5mm (with screen)
- 52*23.5*5.7mm (without screen)
• Weight:
- 7.5g (with screen)
- 5.3g (without screen)
• Measurement range: 2S~8S
• Power consumption (S.Port): 10mA@5V
Power consumption (battery): 10mA
• Voltage display resolution: 0.01V (Only for FLVS with screen)
• Voltage detection precision: 0.05V
• Operating temperature: -20~60℃
• 128*64 OLED Screen (Only for FLVS with screen)
• Compatible with FBUS/S.Port protocol
Warning: Install FrSky Li-Po Voltage Sensor on any appropriate surface of the airframe that stays away
from water, vibration, or fuel.
Set Up
FrSky Li-Po Voltage Sensor is only compatible with FrSky Smart Port enabled receivers. Here we take the setup
together with X8R receiver for example. For more details, please refer to corresponding receiver instruction manual.
Overview
23 mm
35 mm
P-
1S
2S
3S
4S
5S
6S
7S
8S
LI-PO VOLTAGE SENSOR
FLVS
Battery Port
Connect to the LiPo battery
To the S.Port of the
other FrSky Sensors / Recievers
Smart Port
OLED Display
LED

Instruction Manual for FLVS ADV Li-Po Voltage Sensor
FrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: [email protected]
LED Status
FBUS
NO
YES
LED Status
Flash slowly
Flash quickly
S.Port
YES
NO
ID Set Up
Note: All FrSky Smart Port enabled sensors could daisy chain with each other through their Smart Port.
Each type of FrSky Smart Port enabled sensor has its unique physical ID. The ID number could be changed by
ETHOS or FreeLink App.