FTG infinity board User manual

ASSEMBLY & INSTALLATION

Unpack the 2 metal hangers. Attach the 4 small carabiners hooks
to the 4 holes on the back of the Innity board.
Attach the 2 adjustable rope ratchets to the 2 metal hangers and
hang the light. Adjust the rope ratchets to the appropriate height.
Attach the power cord to the driver on the Innity board and
screw the connection together to ensure a watertight seal.
Plug in the power cord.
When assembling a 2-pack or
4-pack of Innity boards, rotate the
boards so that the power connectors
face inwards. This will make connecting
the power cable much easier.
GENERAL ASSEMBLY & INSTALLATION
TIP:
1
2
3
4

Unpack the 2 metal connecting bars (there will be 1 bar in each
box). Connect the 2 lights by using 1 metal bar and 4 screws,
repeat on the opposite side.
Unpack 2 metal hangers. Attach the 4 small carabiner hooks to the 4
corner holes on the back of the Innity boards (2 holes on the left
board and 2 holes on the right board).
Attach the 2 adjustable rope ratchets to the 2 metal hangers and
hang the lights. Adjust the rope ratchets to the appropriate height.
Attach the dual power cord to the drivers on the Innity boards
and screw the connections together to ensure a watertight seal.
2-PACK
1
2
3
4
Plug in the power cord.
5

Follow Step 1 in the 2-pack instructions above to build 2x
2-packs.
Use 2 additional connecting bars on the left and the right to connect
all 4 Innity boards together. In total, you will use 6 connecting bars
and 24 screws.
Detach 4 small carabiner hooks from the metal hangers. Attach
these carabiners to the 4 corner holes on the back of the Innity
boards.
Attach 4 adjustable rope ratchets to the 4 carabiners and hang
the lights. Adjust the rope ratchets to the appropriate height.
4-PACK
1
2
3
4
Attach the quad power cord to the drivers on the Innity boards
and screw the connections together to ensure a watertight seal.
5
Plug in the power cord.
6