Torque volume knob adjustment
Set torque volume knob to the desired fastening torque. For the relation between torque volume
knob calibration, fastening torque,and rotational speed of driving shaft, refer to torque chart shown below:
Product No. Output torque
（N・m）
MO-1330 0.73～3.20
0.48～2.33
0.16～0.90
0.27～1.55
MO-1350 1.19～4.80
※ When X character attaches to the part, the output axis become φ6h8.
Values presented in torque charts and tables are theoretical ones. Therefore, they are different from
values used for actual screw fastening on workpiece.
Fastening torque varies depending on screw size, type, fastening depth, workpiece material, etc.
To obtain the most appropriate torque take various condition into consideration. Output torque means
stall torque provided through electrical energy of motor, so it is different from dynamic torque applied to
actual fastening. Regard it as static torque and make a distinction between static torque and
dynamic torque. For related information, page 12-14.
②Ajustment of motor lock time
※After fastening screw with a determined torque,
keep motor torque at the same level for certain time
( lock time ) . Adjust lock time by inserting minus thread
screwdriver into adjust bolt hole on the top face of
controller and turning it to right or left.
※If workpiece contains cushion material such as rubber
packings, make lock time longer for better fstening.
If lock time is kept long ,keep motor surface temperature
at 60℃ or less.
Consumable parts replacement
Fuse replacement
To remove fuse, insert pin into hole on the top of fuse
holder on the rear panel of controller. If fuse is blown,
replace it with new one.
Lock time Max.
Approx
0.5sec
