Fujitronic FH-777 User manual

TOWER COOLING FAN
WITH REMOTE CONTROL
MODEL: FH-777
Please read this instruction manual carefully before using the unit

2
Safety Instructions
Read and Save This Instruction Manual
1. Read these instructions carefully before attempting to assemble, install, operate or maintain
the unit.
2. Observe all safety precautions fully.
3. Failure to comply with these instructions could result in personal injury and/or property
damage.
4. Save this manual for future reference.
5. This product is for household use only.
6. This product is not intended to be used in commercial or industrial environments
Features
zAir cooling, hydrating and air cleaning functions
zAdopted germ-free water pump circle system
zAdopted cloth curtain materials producing moisturized cool air
zVariable air speed
z60- degree- horizontal air flow with auto swing functions
zCapable of wide-range timer setting (0.5 to 7.5 hrs)
zRemote Control
zLow water alarm function
zLED indicator
For Safe and Effective Operations
1. Make sure that the power source voltage conforms to the electrical requirements of the unit.
(AC120V/60Hz).
2. Do not damage the power cord and plug. If the power cord or plug is damaged, it must be
replaced by the manufacturer, its authorized service agency or qualified personnel in order to
avoid a hazard.
3. When the unit is not in used, disconnect the plug from the power outlet. Grasp the plug, not
the main power cord, when disconnecting the plug. If the unit will not be in used for a long
time, drain the water inside the tank.
4. Do not disassemble or alter the unit.
5. Do not use the unit in areas where temperature is extremely high or low (exceeding 122oF or
below 32oF), or where it may be exposed to direct sunlight.
6. Move the unit slowly to avoid the water from splashing out of the water tank.
7. Do not operate the unit near flammable liquids or in explosive atmospheres.
8. Do not put heavy objects on the unit; it might cause damages or malfunctions on the unit.
9. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of this appliance by a person responsible
for their safety.
10. Children should be supervised at all time to ensure that they do not play with the appliance.
11. Switch OFF and unplug the unit before filling with water. Make sure the water level is under
the MAX line of the water tank.

3
12. Switch OFF and unplug the unit before cleaning and/ or any maintenance.
13. This unit has humidifying function. Please do not use it for a long time in an airtight place
(such as small closed room) to avoid too much humidity.
14. Change the water frequently to keep it clean.
15. This unit must be operated in a horizontal position/ flat surface.
16. This unit shall not be exposed to dripping or splashing water.
17. Do not install the unit in a confined space, such as a bookcase or built-in
cabinet.
18. DISPOSAL: Do not dispose this product as unsorted municipal waste.
Important Warnings:
1. This unit should not be adjusted or repaired by anyone except authorized service agency.
2. If the unit tips over, please pull out plug from power outlet at once, then take the unit to
authorized service agency for check or repair.
Product Appearance and Operation
Figure1

4
Remote Control and Its Operations
1. Please operate the Remote Control
within 6 meters from the unit.
2. If the remote control does not
work in a short distance from
the unit, please open the battery cover with
a tool (such as a coin) and change the batteries.
3. Do not allow children to play with
the remote control.
Figure 2
Before Operation
1. Draw out the water tank and fill in with water before using this unit. Refer to the Figure 3，
Please DO NOT pour the water above 104oF into the water tank.
2. ICE and ICE BOX can be added into the base water tank (optional). Please refer to Figure 4
Figure3 Figure4
Note:
1) Do not put the ICE BOX into the water tank when the base water tank is full. Water may
overflow.
2) The ICE BOX should be frozen before using.
3) The ICE BOX is sealed by manufacturer.
4) Even thought the gel inside the ICE BOX is NOT harm to human, but do not try to open the
ICE BOX and put the gel directly in the water tank. The gel may damage the water pump and
the water running system.

5
General Operation (Please refer to the Figure 5)
Figure5
POWER button
1. Connect the plug to the power outlet, and a beep tone will be heard.
2.
Press the POWER button, the FAN indicator and HIGH speed indicator will be turned on with a
beep tone. The default start up setting is of this unit is high fan speed at normal mode.
3. Press the POWER button again to turn the unit off.
MODE button
When the unit is ON, press the MODE button once and the NATURE mode is on . Press the
MODE button again to change to the SLEEP mode; press the MODE button for the 3
rd
time
and it will change to Normal mode again.
HIGH speed+ NATURE mode:
In NATURE mode, press the SPEED button to HIGH. Both HIGH and NATURE indicators
will be on. The wind speed will change automatically as follows:
-HIGH speed 5 sec. ÆLOW speed 5 sec. ÆMED speed 5 sec. ÆStop 5 sec. ÆMED
speed 10 sec. ÆHIGH speed 10 sec. ÆMED speed 5 sec. ÆLOW speed 5 sec. Æ
Stop 5 sec. ÆMED speed 5 sec. ÆHIGH speed 5 sec. ÆLOW speed 5 sec. ÆStop 5
sec. The unit will work continuously in this mode until the unit is power off.
MED speed + NATURE mode:
In NATURE mode, press the SPEED button to MED. Both MED and NATURE indicators will
be on. The wind speed will change automatically as follows:
-MED speed 5 sec. ÆLOW speed 5 sec. ÆMED speed 5 sec. ÆLOW 5 sec. ÆStop
5 sec. ÆMED speed 10 sec. ÆLOW speed 10 sec. ÆMED speed 5 sec. ÆLOW 5
sec. ÆStop 5 sec. ÆMED speed 5 sec. ÆLOW speed 5 sec. ÆStop 5 sec. The unit
will work continuously in this mode until the unit is power off.

6
LOW speed + NATURE mode:
In NATURE mode, press the SPEED button to LOW. Both LOW and NATURE indicators will
be on. The wind speed will change automatically as follows:
-MED speed 5 sec. ÆLOW speed 15 sec. ÆMED speed 5 sec. ÆLOW 15 sec. ÆStop
5 sec. ÆMED speed 5 sec. ÆLOW speed 10 sec. ÆMED speed 5 sec. ÆLOW 10
sec. ÆStop 5 sec. ÆMED speed 5 sec. ÆLOW speed 20 sec. ÆStop 5 sec. The unit
will work continuously in this mode until the unit is power off.
HIGH speed+ SLEEP mode:
In SLEEP mode, press the SPEED button to HIGH. Both HIGH and SLEEP indicators will be
on. The wind speed will change automatically as follows:
- First 0.5 hr: HIGH and MED speed wind alternate in every 10 sec
-Second 0.5 hr: MED speed wind
-After 1hr or until the unit is power off: LOW speed wind
MED speed + SLEEP mode:
In SLEEP mode, press the SPEED button to MED. Both MED and SLEEP indicators will
be on. The wind speed will change automatically as follows:
- First 0.5 hr: MED and LOW speed wind alternate in every 10 sec
-After 0.5 hr or until the unit is power off: LOW speed wind
LOW speed + SLEEP mode:
In SLEEP mode, press the SPEED button to LOW. Both LOW and SLEEP indicators will
be on.
- LOW speed wind for 10 seconds and stops for 5 second. This process alternates in every
15 seconds until the unit is power off.
Note: To avoid overcooling, do not adjust the wind direction directly to human body.
SPEED button
1. When the POWER button is pressed, HIGH
speed indicator “HIGH” will be on and the
strongest wind comes out.
2. Press the SPEED button once, the MED
speed indicator “MED” will be on and the mild
wind comes out.
3. Press the SPEED button again, the LOW
speed indicator “LOW” will be on and the softest
wind comes out.
SWING button
Press the SWING button and the wind bar will start swinging. The swing can cover up to 60
degrees horizontally. Press the SWING button again to stop the wind bar at a desired
position.
TIMER button
1. Press the TIMER button to adjust the timer setting. Each press adds 30 minutes to the timer
and it can be set for up to 7.5 hours. The set timer is indicated on the display.

7
2. To clear the timer mode, press TIMER button for 16 times (one more press after it reaches 7.5
hours); the TIMER indicator will be off. Or POWER off the unit to reset all setting.
COOL button
1. Press the COOL button, if the water level is above the minimum level, the COOL indicator
will be turned on and the pump will start working.
2. After about 3 minutes, the comfortable cool wind with moisture will come out from the unit.
3. Press the COOL button again to turn the COOL mode off. The COOL indicator will be
turned off too and fresh dry wind will come out.
Note:
1. If COOL mode is selected when the water is under the low level or no water at all, the
alarm will sound after 90 sec. The COOL indicator will blink continuously for about 10 sec.
After 10 sec, the alarm stops and the COOL mode will be turned off too.
2. The unit can be used without water as a normal electric fan. In this situation, please keep
the COOL mode OFF.
Specifications
Rated
Voltage Rated Frequency Rated Power Water Consumption
Water
Tank
Capacity
Dimensions
(inch) WxDxH N.W. (lbs)
120V~ 60Hz 80W 0.2-0.25L/h 4L
12.13x11.50x 34.76 11.24
Cleaning andMaintenance
zIMPORTANT! Disconnect the plug from the power outlet before cleaning and maintenance
zThe body of the unit should be cleaned with damp cloth moistened with mild soap. Do not
clean it with wet cloth.
zFrom time to time, depending on the nature of your water supply, you may need to clean the
interior of the water tank. This can be done in the following manner:
1) Fill the water tank with 1 cup (8 oz.) undiluted white vinegar;
2) Let the solution stand for 20 minutes.
3) With the vinegar in the water tank, clean all interior surfaces with a soft cloth or brush to
help remove scale.
4) Rinse the water tank thoroughly with clean water to remove scale and cleaning solution.

8
To Clean the Filter and Water Curtain (Please refer to Figure 6)
In order to keep good condition for humidifying and purifying, please clean the filtering system once
every two weeks.
Figure 6
1. Remove the back cover with dust filter from the unit;
2. Take out the water curtain from the unit;
3. Wash the filter net and water curtain with water. Then put it under sunlight to dry;
4. Install the dry water curtain into unit;
5. Install the back cover with dry filter onto the unit.

9
General Problems and Solutions
Problems Reasons Solutions
No air
blows out
zNo power
zNo operation
zSome parts are damaged
zConnect the plug to the power outlet.
zPress the POWER button on the unit.
zTake the unit to authorized service agency.
The unit
can not be
turned off
zPOWER button is not
pressed
zSome parts are damaged
zPress the POWER button to turn the unit
off.
zTake the unit to authorized service agency.
The unit
has noise
zForeign objects are
inside the unit
zMotor is out of order
zAir wheel is loose
zTake off the side cover board and filtering
net then take out the objects.
zTake the unit to authorized service agency.
zTake the unit to authorized service agency.
No
humidifying
zLack of water
zPump is out of order
zWater pipe drops off
zAdd the water.
zTake the unit to authorized service agency
zTake the unit to authorized service agency.
No swing zSwing motor is out of order zTake the unit to authorized service agency.
SERVICE AND WARRANTY
Fujitronic warrants this product to be free from defects in materials and workmanship for one
(1) year from the date of original purchase. If you have a claim under this warranty, please return
the defective product to the original place of purchase for repair or replacement. Proof of purchase
is needed.
Fujitronic warrants this product to be free from defects and malfunction under ordinary and
appropriate use. Fujitronic disclaims all responsibility for inappropriate actions, directly or indirectly
cause the damage of this product.
The free of charge repair service does not cover the housing enclosure, flexible cord, plug
and defects caused by improper use or negligence of the user.
Los Angeles Headquarter
15329 Don Julian Rd
City of Industry CA 91745
Tel: [phone]
Fax: [phone]
DISCLAIMER: ALL INFORMATION AND TECHNICAL SPECIFICATIONS PRESENTED IN THIS USER’S MANUAL ARE THE
PRESENTATION OF THE MANUFACTURER. FUJITRONIC HAS NOT CONDUCTED INDEPENDENT TEST TO THE
INFORMATION AND THE SPECIFICATIONS PRESENTED HEREWITHIN.