Fujitsu P1610 - LifeBook - Core Solo 1.2 GHz Reference guide

LifeBook P1610
Bluetooth Board Replacement
ESD Precautions are required when working on this LifeBook computer.
Make sure the LifeBook is turned off before beginning this procedure.
1. Turn the LifeBook over and
remove the battery
3. Release the cable by flipping the
latch up.
2. Extract these 3 screws from the
Hard Disk Drive cover and lift it off.
4. Lift the Drive out.

5. Extract 11 screws from the lower
case.
7. Open the LifeBook and lay it flat.
9. Lift the top edge of the keyboard
up and turn it over
11. Tilt the Display up and rotate it ¼
turn.
6. Extract 2 screws from the rear of
the LifeBook.
8. Use a plastic pry tool to remove
the keyboard upper trim.
10. Disconnect the keyboard and
ClickPoint cables from the system
board by pulling them gently.
12. Slide out the lower hinge cover.

13. Turn the Display back and lay it
down.
15. Extract 2 screws from the Display
hinge.
17. Extract 4 screws from the upper
case and open the external VGA
connector cover.
19. Lift off the upper case.
14. Disconnect 2 Display cables from
the system board and the 2 antenna
cables from the WLAN Card.
16. Lift the Display off the lower
assembly.
18. Disconnect the ClickPoint button
cable and the speaker cable from
the system board.
20. Disconnect the IO Board ribbon
cable, the Bluetooth ribbon cable
and the Bluetooth antenna cable.

21. Extract 1 screw from the
Bluetooth board and lift it out.
23. Connect the Bluetooth ribbon
cable, the Bluetooth antenna cable
and the IO Board ribbon cable.
25. Close the external VGA
connector cover and secure the
upper case with 4 screws.
27. Secure the display with 2 screws
in the hinge.
22. Transfer the ribbon cable from
the defective board, insert the new
one and secure it with 1 screw.
24. Place the upper case and
connect the ClickPoint button cable
and the speaker cable.
26. Extract 3 screws from the PCB.
28. Attach the 2 display cables to
the system board and the 2 antenna
Cables to the WLAN card.

29. Tilt the display up and rotate it ¼
turn
31. Turn the Display back and lay it
down.
33. Turn the keyboard over and slide
it into place
35. Close the LifeBook and turn it
over.
30. Slide the lower hinge cover into
place.
32. Plug in the cables for the
keyboard and ClickPoint.
34. Press the keyboard upper trim
into place.
36. Insert 2 screws into the rear of
the LifeBook.

37. Insert 11 screws into the lower
case.
39. Press the latch down to lock the
cable into place.
41. Replace the battery.
38. Insert the Hard Drive.
40. Replace the Drive cover and
secure it with 3 screws.