Fujitsu fi-5220C Configuration guide

Cleaning Instructions for
fi-5220C Scanner
It is recommended that these items be
cleaned EVERY 1,000 SCANS
Consumables Part Number
Consumable Kit CON-3289-003A
Cleaning Kit SC-CLE-WGD
Using F1 Impregnated Cleaning Wipes

Pad Assy
Wipe downwards. When cleaning take care to prevent the cleaning wipe from catching on the
metal parts.


Turn the Scanner OFF while cleaning the following locations
ADF Glass Surfaces x 2
Located on the ADF cover and opposite side. Clean lightly.
Pick Roller
Clean lightly taking care not to scratch the surface.
P.T.O.




Plastic Rollers
Feed Rollers
Glass
Pick Roller
Pad Assy


Plastic Rollers x 4
Clean lightly while rotating with your finger. Take care not to roughen the surface.

Document Holding Pad
Document Bed
Cleaning the Flatbed
Open the document cover, clean:
Using F1 Impregnated
Cleaning Wipes
BEFORE CLEANING
Open the ADF while pressing
the cover open button
ADF Button


Feed Rollers x 2
Clean lightly while rotating with your finger. Take care not to roughen the surface.
For further information please refer to the
fi-5220C Scanner Operators Guide
Which can be found on our Website:
http://www.fujitsu.com/emea/products/
January 2010
Using F1 Impregnated Cleaning Wipes
Turn the Scanner ON while cleaning the following locations
PFU Imaging Solutions Europe Ltd Cleaning Instructions for fi-5220C Scanner
Open the ADF only if the Function Number Display is
showing “1” through “9”.
Simultaneously hold down the “Send to” and “Scan”
buttons on the operator panel. The Feed Rollers will
start to rotate slowly.
Hold the cleaning wipe against the surface of the rotating
rollers, lightly cleaning the surface.
As a guideline, 7 presses of the “Send to” and “Scan”
buttons make the rollers rotate one full turn.




Plastic Rollers
Feed Rollers
Glass
Pick Roller
Pad Assy

 
“Send to” Button “Scan” Button