Fujitsu FI-4990C Configuration guide

BEFORE CLEANING
Remove documents from the stacker.
Pull up the lever on the right front of
the upper transport and raise it.
Cleaning the Rollers - Recommended Cleaning Cycle Every 100,000 Sheets
Parts Part Number
Pad CA04315-G730
Pick Roller CA04315-F711
Brake Roller CA04315-F705
Cleaning Kit SC-CLE-KIT2
Note: Please ensure Cleaner F2 is NOT used on
Rubber Rollers
Cleaning Instructions for
fi-4990C Scanner
Brake Roller
(hidden)
Pick Roller Unit
Rollers
Metal
Rollers
Open the upper transport unit. Using cleaning paper moistened with F1 cleaner, wipe the
Pick Roller Unit, Brake roller and upper and lower Transport Unit Rollers.
Cleaning the Metal Rollers
Using cleaning paper moistened with F2 cleaner, wipe the Metal Roller surfaces (lower
transport unit side) while turning the shaft by hand.
P.T.O.

Cleaning the Glass Surface (Upper Sheet Guide Assembly)
Recommended Cleaning Cycle Every 200,000 Sheets
1
2
3
Open the Upper Transport Unit
Loosen the two knurled screws at both ends of
the Upper Sheet Guide Assembly to open.
Wipe both surfaces of the glass with cleaning
paper moistened with F1 cleaner as necessary
Close the Upper Sheet Guide Assembly and
tighten the two Knurled Screws.
4
Cleaning the Glass Surface (Lower Sheet Guide Assembly)
Recommended Cleaning Cycle Every 200,000 Sheets
For further information please refer to the
fi-4990C Image Scanner Operators Guide
which can be found on our Website:
www.fel.fujitsu.com/scanner
January 2007
Cleaning Instructions for fi-4990CFujitsu Europe LImited
Glass
Lower Sheet Guide
Assembly
Tab
1
2
3
Open the Upper Transport Unit
Pull down on the Lower Sheet Guide Assembly tabs
to remove.
Wipe both surfaces of the glass with cleaning paper
moistened with F1 cleaner
Align the Lower Sheet Guide Assembly in the Guide
Rails and push back into place
4
Knurled Screws