Furinno 11259 User manual

MODEL: 11259
NO-TOOL 5 DRAWERS CHEST
Date: 16.10.2014

BEFORE YOU BEGIN, PLEASE READ ASSEMBLY INSTRUCTIONS CAREFULLY.
FOLLOW THEM STEP BY STEP.
CAUTION:
1. ADULT SUPERVISION IS REQUIRED DUE TO SMALL PARTS.
CARE SHOULD BE TAKEN IN THE UNPACKING AND ASSEMBLY OF THE PRODUCT.
2. ASSEMBLE ON SOFT SURFACES TO PREVENT DAMAGE TO THE PRODUCT FINISH.
3. MAKE SURE ALL PARTS ARE INCLUDED BEFORE ASSEMBLY.
Date: 16.10.2014

ASSEMBLY INSTRUCTION
STEP 1
INSERT DOWEL (1) TO THE PRE-HOLES OF PANEL (B)(C)(D)(E)(F)(G).
STEP 2
FIX SWITCH LOCK (5) INTO THE CAM LOCK OF EVERY PANELS, BEFORE ASSEMBLY THE UNIT.
Date: 16.10.2014

STEP 3
ATTACH PANEL (D)(E)(F)(G) TO PANEL (B).
TURN ON CAM LOCK AND FIX INTO THE PRE-DRILL NUT.
TURN OFF CAM LOCK WHEN THE PANEL WERE FIXED.
Date: 16.10.2014

STEP 4
ATTACH PANEL (C) TO ASSEMBLED UNIT.
REPEAT THE SAME METHOD AS STEP 3.
STEP 5
UPRIGHT THE UNIT. ATTACH PANEL (A) TO IT.
REPEAT THE SAME METHOD AS STEP 3.
turn off lock
Date: 16.10.2014

STEP 6
FIX PANEL (M) TO THE REAR POSITION OF UNIT.
INSERT PLASTIC PIN & NUT (3) AND PLASTIC STOPPER (2) INTO THE PRE-HOLES OF PANEL (M).
Date: 16.10.2014

STEP 7
ATTACH PANEL (K) TO PANEL (I)(J).
REPEAT THE SAME METHOD AS STEP 3.
STEP 9
FIX THE HANDLE SET (4) TO THE PANEL (H).
STEP 8
SLOT IN PANEL (L) TO PANEL (I)(J), AS SHOWN.
ATTACH PANEL (H) TO THE ASSEMBLED SECTION.
REPEAT THE SAME METHOD AS STEP 3.
Date: 16.10.2014

Date: 16.10.2014
STEP 11
IT IS STRONGLY RECOMMENDED THAT THE DRAWER CHEST IS FIXED TO A WALL.
USING WALL MOUNTING SET (6), ATTACH THE L-BRACKET TO THE TOP OF THE DRAWER CHEST
WITH SHORT SCREW. DRILL A HOLE SMALLER THAN THE ANCHOR PLUG, INSERT THE ANCHOR
PLUG INTO THE HOLE USING A RUBBER MALLET UNTIL THE ANCHOR PLUG IS FLUSH WITH THE
WALL, THEN FASTEN IT WITH LONG SCREW.
STEP 10
SLIDE 5 NOS. OF DRAWER INTO TH UNIT.
INSERT RUNNER STOPPER (7) TO THE PRE-DRILLED HOLE
OF DRAWER SIDE PANEL (I)(J), AS SHOWN.