Furnlink AVOCA User manual

AVOCA CHAIR ASSEMBLY INSTRUCTIONS

AVOCA CHAIR ASSEMBLY INSTRUCTIONS
1 - This images shows the shell, legs & pack of screws, spring washers, washer, feet, rubber plugs & allen
key & white plastic fittings
2 –Place the shell upside down on a bench
3 –Stand the legs up to form a frame –no screws have been used to do this
4 –5 screws are provided –one is shorter
5 –Place the spring washers over the 5 screws as shown –then place the washer over shorter screw

6 –Place the legs (still not screwed together) to form the frame –upside down as shown
7 –Place the shorter screw in the centre
8 –Screw in with the allen key loosely –NOT TIGHT
9 –Place the frame on the shell, with the arrows pointing towards the FRONT of the shell

10 –Place the white plastic fitting over the legs & allow to slide down –match up with the screw holes
in the legs
11 –Place the longer screws into the holes
12 –Screw in with the allen key –loosely first until all are loosely screwed then TIGHTEN
13 –Screw in the centre screw TIGHTLY

14 –Push in the plastic chair feet
15 –Place the rubber plugs into the white plastic fittings
16 –The chair is completed correctly