Furnlink CORIO MK2 User manual

ASSEMBLY INSTRUCTIONS FOR CORIO MK2 CHAIR

ASSEMBLY INSTRUCTIONS FOR CORIO MK2 CHAIR
STEP 1.
Unpack the boxes. Each box should contain:
4 x Chairs (with no seat attached)
4 x Padded Seats
2 x Long Bolts
2 x Short Bolts
4 x Washers
1 x Allen Key
STEP 2.
Place the padded seat upside down on a bench top or sturdy table, with the back of the seat
(narrower end) toward the edge of the bench as shown.
STEP 3.
Place the Chair onto the seat pad as shown.
Back of Chair
Back of seat (narrow end)
STEP 4.
Place the washers over each bolt

STEP 5.
Hand tighten the Long Bolts into the front of the chair, as shown. Do not tighten with Allen Key or
Electric drill yet.
STEP 6.
Fasten the Short Bolts into the back of the chair, using the Allen Key provided or an Electric Drill with
a Hex Drill Bit.
STEP 7.
Now, tighten the front bolts using the Allen Key or the Electric Drill. Your chair is complete!
Front of Chair
Long Bolt
Washer
OR
Back of Chair –use Allen Key to tighten
Or use Electric Drill