Furrion Greystone GGR21D3DA3B-SS User manual

21" Freestanding Digital Gas Range
with Dual Storage Drawers
Model (Lippert PN)
GGR21D3DA3B-SS (2023046478)
GGR21D3DA3B-BG (2023046479)

Function
Cooking Tip
Range Features
Product Troubles shooting
Sanitation & Upkeep
Product Warranty Information
14
20
21
22
23
25
Rev.10.16.23
2
CCD-0008340

3
Rev.10.16.23
3
CCD-0008340

Rev.10.16.23
4
CCD-0008340
Rev.10.16.23
4
CCD-0008340

Rev.10.16.23
5
CCD-0008340
Rev.10.16.23
5
CCD-0008340

Rev.10.16.23
6
CCD-0008340

FIRE, EXPLOSION, BURN INJURY, CARBON MONOIXDE POISIONING
The cooking appliance must be completely separated and/or sealed from
other air moving or air consuming devices such as, but not limited to
furnaces, microwaves ovens, clothes dryers, cooling fans and doors or
drawers in common cabinets. Failure to do so will affect the appliance(s)
combustion air supply by creating either a negative or positive draft.
Rev.10.16.23
7
CCD-0008340

NEGATIVE DRAFT caused by air moving appliances may draw the top
burner flame down into or toward the cooktop resulting in cooktop damage,
burn hazard, explosion possibility and/or carbon monoxide poisoning.
POSITIVE DRAFT may blow out the top burner flame during use resulting
in an explosion and/or fire hazard and/or injury to the occupants of the
vehicle.
DO NOT operate unit in excessive windy conditions as this may cause a
negative or positive draft.
Gas leaks may occur in the system and result in dangerous conditions. In
some situations, a gas leak may not be detectable by smell. Gas suppliers
recommend you purchase and install a UL approved gas detector. These
detectors should be installed in accordance with the manufacturer's
instructions.
Rev.10.16.23
8
CCD-0008340

Rev.10.16.23
9
CCD-0008340

construction and the back of the appliance.
The minimum distance from the center of the rear burner to the
combustible wall behind the range is 9".
The minimum distance from the center of the rear burner to the
combustible side wall next to the range is 7.25".
The side cabinet that is located between the appliance and the
combustible construction has a minimum height requirement
from the cooking surface to the bottom of the cabinet of 18"
(457 mm) above the cooking surface.
Rev.10.16.23
10
CCD-0008340

The minimum horizontal distance between overhead cabinets
must not be less than width of the appliance.
The maximum depth of the cabinets installed above the top
surface of the cooking sections can be no more than 13"
(330mm). Any opening in the wall behind the appliance and in
the floor under the appliance shall be sealed. If the cabinet is
deeper than 13", it must be protected by a non combustible
panel or material.
Cabinet directly over the range must be a minimum of 30" from
the cooking surface (Top of grate).
If using a range hood or microwave product over the range, see
range hood or microwave manual for installation requirements.
7.25" (184mm)
(Center of rear burner to side wall)
(Cooking surface - Top of grate)
30" (762mm)
(Cooking surface - Top of Grate)
7.25" (184mm)
(Center of rear burner to side wall) 9" (229mm)
(Center of rear burner to back wall)
Anti-Tip \ Front Foot Bracket Installation
18" (457mm)
Rev.10.16.23
11
CCD-0008340
. The anti-tip bracket can be

Secure front bracket with wood
screw (Recommend #8-15 x 1"
wood screw, not provided).
Slide the front bracket forward
onto the front foot until it is
fully seated into the bracket.
Move the appliance to the final position
Slide the front foot bracket under the front of the range and push until
bracket is up against the front foot.
Secure bracket to the floor. (Recommend #8-15 x 1" wood screw, not
provided).
21.4in (54.4cm)
22in (55.8cm)
23in (58.2cm) 20.7in (52.7cm)
21.3in (54cm)
19.7in (50cm)
18.7in (47.4cm)
19.3in (49cm)
35.9in (91.2cm)
Model C
463.5mm
Min
18.25”
562mm
Min Max
22.13”
912mm
36”
21"
Freestanding
A B
The contour line of back panel of appliance
0.654in
3.08”
3.07in
3.35”
4.47in
The contour line of front panel of appliance
The contour line of left panel of appliance
The contour line of right panel of appliance
Rev.10.16.23
12
CCD-0008340

button to the desired oven temperature.
Rev.10.16.23
13
CCD-0008340

5 to 10
seconds.
4.To adjust to the desired flame, push and rotate the burner control
knob.
Rev.10.16.23
14
CCD-0008340

Rev.10.16.23
15
CCD-0008340

Rev.10.16.23
16
CCD-0008340

All combustion flames need to be visually
checked to determine their flame quality.
1. Yellow tips on outer cones-Normal for LP gas
operation.
2. Yellow flames-Abnormal for any gas operation;
call for service.
lf burner flame looks like 3, the range should not be used until it is serviced.
Call for service. Normal burner flames shall look like 1 or 2.
quality:
lights
performed
Before operating the gas range, always perform
Rev.10.16.23
17
CCD-0008340

-Leak testing of the appliance shall be conducted according to the
manufacturer’s instructions. Do not use a flame to check for gas leaks.
Use a brush to spread a soapy water mixture around the area you are
checking. If there is a gas leak, you will see small bubbles in the soapy
water mixture at the leak point.
A manual valve shall be installed in an accessible location in the gas
piping external to the appliance for the purpose of turning on or shutting
off gas to the appliance.
NEVER cover any slots, holes or passages in the oven bottom or cover
an entire rack with materials such as aluminum foil. During so blocks airflow
through the oven and may cause carbon monoxide poisoning. Aluminum
foil linings may also trap heat causing a fire hazard.
Top burner flame size should be adjusted so it does not extend beyond
the edge of the cooking utensil.This instruction is based on safety
considerations. Possible hazards or injuries may resullt from the misuse
of appliance doors or drawers such as stepping, leaning or sitting on the
doors or drawers.
loose joint properly.
Rev.10.16.23
18
CCD-0008340

and or cooktop (maximum pan size = 10 inches).
when not in use.
.
Rev.10.16.23
19
CCD-0008340

8
Drawer
Top Glass Cover
Rev.10.16.23
20
CCD-0008340