Fursys Sidiz T50 Series User manual

CastersStar BaseScrews for
Armrest Assembly
01 02
Armrest and Seat Pan Assembly Backrest and Seat Pan Assembly
1. Prepare 2 bolts and a wrench for each armrest. 1. Prepare 4 bolts and a wrench for backrest assembly.2. Insert an armrest into the seat pan and assemble
with bolts.
2. Match the backrest into the seat pan and assemble
with bolts.
Caution
• Please read the assembly instruction sheet completely before assembly.
• Remove all parts from carton and ensure all parts are included prior to assembly.
• Assemble the chair on the carton or table to prevent scratching the chair.
• Do not use power tools.
• Examine all packaging materials and remove staples before discarding carton.
• For immediate help with assembly or product information,
please contact [e-mail].
• The parts of the product may be slightly dierent from the pictures.
|
Using the allen wrench
|
1. Use the allen wrench when you assemble the bolts.
2. Use the long end of the allen wrench when the bolts need to be fastened quickly.
3. Use the short end of the allen wrench for final tightening.
SIDIZ is not responsible for any claims/defects on products or wounds on the user caused
during assembly.
Assembly Instructions
T50
Series
Scan QR Code for
Assembly Video
Parts List
Screws for
Backrest Assembly
Spare Screws for
Backrest Assembly
Backrest Armrest Gas LiftSeat Pan
Headrest Headrest Cover
Screws
•
Option
•
Spare
Wrench
[e-mail]
* The latest version of the manual
may be found on Amazon's product detail page.
www.globalfursys.com

1. When taking the cover o, peel from the back side of the chair.
Seat cover for T50 air - Putting on the seat cover
04Final Assembly
3. After installing the cylinder, sit on the chair and check
if the chair height adjustment lever is fully functional.
03Star Base, Gas Lift Assembly
1. Combine the upper part of the chair with the already
assembled bottom part.
2. Fix the cylinder on to the hole located below the upper
part of the chair.
1. Assemble on a smooth surface in order not to scratch
the parts.
2. Turn the star base 1upright and insert the gas lift 2
into the center hole of Star Base.
2Gas Lift
1Star Base
02 1
Headrest
2
Headrest Holder
Headrest (Option) - Headrest AssemblyHeadrest (Option) - Cover Assembly
01
1. Place the headrest cover
3
and use 2 bolts
1
to install
it with the backrest
4. Then attach the logo cap 2
into
the backrest.
1. Insert the headrest
1
to the headrest holder
2
on the top
of the Backrest.
1
Bolts for
Headrest Assembly
4
Backrest
3
Cover
2
Logo Cap
1. Place the cover so that the flat line comes to the front. 2. Cover the front part of the chair first, and move to the
back in sequence.
Seat cover for T50 air - Taking the cover o