Note 1
Take care to make sure the wires are
spliced in the correct phase. Positive
to positive, negative to negative.
Failure to do this correctly could
result in loss of bass.
See Note 1
Splice into source
unit’s speaker wires
(R+) Grey/White
(R- ) Grey
(L+) Green/White
(L-) Green
Connect the remote bass level controller
lead to the amplifier
Connect red wire
to positive (+12V)
battery terminal
Connect blue wire to source unit’s
accessory lead or switched 12 volt
source (REM)
Connect black wire
to chassis ground
of vehicle (Ground)
Speaker Level
Input Plug
Remote Bass Level Controller
Vehicle Battery
SPECIFICATIONS
EN-AW1121
Power (Watts) 1000
Rated Amplifier Power (Watts) 150
Frequency Response 34Hz - 250Hz
Low Pass Filter (Variable) 40Hz - 250Hz
Tuning Bass Reflex
Woofer Size 12”
Fuse 25A
Dimensions (mm) 567(l) x 400(w) x 389(h)
22-5/16” x 15-6/8 x 15-11/32”
CONTROL DESCRIPTIONS
LEVEL
This allows the adjustment of the amplifier level of
the subwoofer. Turn clockwise to increase the level.
If the sound becomes distorted reduce the level.
LOW PASS FILTER (LPF)
This allows the adjustment of the highest
frequency the Active Wedge will produce. This
should be adjusted to blend with your main
speakers. Typically, this will be set to around
100Hz (approximately the central position of the
control knob).
BASS REMOTE CONTROLLER
This control can be mounted in the front of the
vehicle to give you control of your Subwoofer’s
output level.
DISCLAIMER
Always ensure the Active Wedge is securely attached, to avoid movement. FUSION accepts no responsibility for
damage or injury in relation to inappropriate securing of this product.
WIRING
• Connect the ground wire to the vehicle
first (clean dirt and paint to bare metal).
• Connect the remote on (blue wire).
• Connect the RCA cables if applicable, OR
• Connect the speaker level wire by
splicing into the headunits speaker
wires. See Note 1 on adjacent page.
• Connect the remote level controller with
the supplied lead.
• Connect the 12 volt (red wire) to the
positive battery terminal.
• Check all connections.
PUBLISHED BY FUSION ELECTRONICS LIMITED: © Copyright 2011 by FUSION Electronics Limited. All rights reserved. Specifications and design are subject to change without notice.
YOU CAN HELP PROTECT THE ENVIRONMENT! Please remember to respect the local regulations: Hand in the non-working electrical equipment to an appropriate waste disposal center.
WARNING: Audio Systems can produce sound levels over 135dB. Continuous exposure to sound pressure levels over 100dB may cause
permanent hearing loss! Please watch for emergency vehicles as warning signals may not be heard. USE COMMON SENSE!
For further product and installation information, please visit www.fusionelectronics.com
Pour plus d’informations sur les produits et l’installation, rendez-vous sur www.fusionelectronics.com
Para obtener más información acerca de los productos y de su instalación, visite el sitio web www.fusionelectronics.com
Bezoek www.fusionelectronics.com voor meer product- en installatie-informatie.
Weitere Produkt- und Installationsinformationen finden Sie unter www.fusionelectronics.com
Per ulteriori informazioni sui prodotti e la loro installazione, potete visitare www.fusionelectronics.com
Для получения дополнительной информации о продуктах и установке зайдите, пожалуйста, на:www.fusionelectronics.com
REGISTER YOUR PRODUCT ONLINE:
For your own peace of mind, register your product purchase online at www.fusionelectronics.com
We’ll keep you up to date with any news related to your product, and any new accessories to help you get
the most from your product.
This product is backed by a 1 Year Limited Consumer Warranty and by registering your product you can be
assured that if the unexpected occurs we’ll have your details and be ready to help.
INSTALLATION
Make sure the Active Wedge is firmly fixed in your
vehicle. Check before drilling or cutting holes. DO
NOT work near gas tanks, fuel lines, hydraulic
lines or electrical wiring.
DO NOT mount the Active Wedge in such a way as
to pinch or damage the wires.
Make sure everything is firmly connected, before
attaching the +12V wire. Ensure the +12V wire is
fused as close as possible to the battery. Always
use a fuse with the recommended rating.
ENCOUNTER ACTIVE WEDGE
EN-AW1121
